Routing

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Labels

Forum Posts

I have a bundle of 2 T1 into a multilink interface. However, I have encounter an issue, last week, our ISP lost one of the T1 and it went down hard for at leats two hours. Once the T1 came up, the bandwidth still was 1544, but once I shutdown and no ...

Hi,Is there anybody who would have a definition for the (queue depth/total drops/no-buffer drops) 0/0/0 statistics when we used the show polilcy-map interface XXI would like to know if the queue depth is the physical size of the queue and what is the...

Steph1963 by Level 1
  • 24280 Views
  • 3 replies
  • 0 Helpful votes

Hi, can someone please help with the following configuration? I have an ADSL modem, IP 192.168.1.1 which is connected to FastEthernet0/0 IP address 192.168.1.2 and then I would like to use the other ethernet interfaces to attach to it two wireless ro...

We have a Cisco 3845 router and on the G0/0 interface we have our public switch with multiple public IP addresses (servers, routers, etc..) and on the S0/0 interface we have a DS3 Internet connection. I need to limit the bandwidth from the Internet (...

I've been trying to be selective in the static routes I want to redistribute from static into my OSPF area.  It looks like the route-map I've created is being ignored by OSPF during the redistribution process.  Anybody out there know if it's possible...

bcturner by Level 1
  • 10414 Views
  • 2 replies
  • 0 Helpful votes

We normally interconnect an ethernet VLAN via a bridge-group to an ATM PVC like : interface ATM1/0.162055 bridge 10 pvc 16/2055  encap aal5snap!interface port-channel1.10 encapsulation dot1q 10 bridge 10!bridge 10 protocol ieeeThis works fine on our ...

signet by Level 1
  • 1282 Views
  • 1 replies
  • 0 Helpful votes

Good afternoonWe have a 887VA and a dns/web/mail/ftp server behind (below address 192.168.99.100).first problemI forwarded the necessary ports to the server address, but now the domain became invisible and all the above servers stops to respond.secon...

Hi Does any one has an idea about the reason of following NTP error. I am unable to configure further ntp peers on the router. Could not able to understand the reason of 100 peers. I am adding only 2nd peer on the router but getting this error. There...

kthned by Level 3
  • 1590 Views
  • 2 replies
  • 0 Helpful votes