Routing

I installed m0n0wall in a virtualized environment, i have 10 PCs connected to a router ( 192.168.1.0/24) which connect them to the internet through PPPoE, the problem is that this router does not have a QoS so what i want to do is the following :-let...

Hi,  I have a question on bgp-rip interaction. Your help is highly appreciated. I have following topology.|R1|------|R4|-----|R2|R1 and R2 are having route 192.168.50.0  learned by some other means(not from R4) which is out of this question.EBGP sess...

Hi,I have setup a VPN server on cisco 1841 and dialed through pc, it worked fine. But when I dial through another ISP it is not working. It can establish VPN but it can't pass traffic through VPN, what may be the problem. The configuration is same an...

Hello,I have split tunneling enabled on Cisco Router and using Cisco VPN client to connect PC to office as well as browse local Internet.However when I want to print to a local printer I cannot. I keep having to add static routes on the PC to allow...

folks,I have a strange issue with 4500 E chassis loaded with SUP 7L-E which always remains in ORANGE LED status, also the uplink ports interface is down and the line protocol is down  but when i execute the command sh int gig1/5 it show me the media ...

HelloOccurred in my customer's device log.I do not know what the message below.Version 12.2(33)SRD4 , WS-SUP720-3BXL This is what is the problem?gle_fab)-> start_sync_to_active_state (c0_ok_active)-> c0_ok_to_active_state (c1_ok_active)-> ok_to_activ...

Hi,  "neighbor filter-list weight" command under bgp configuration is deprecated. If I want to assign certain weight to the routes received from a specific neighbor, how can I do that in the latest release?Thanks,Balajee

I am not sure if this question belongs here or in the WAAS catagory as I am running the router with WAAS express. I am figuring here since it revolves around the status of the buffers on the router. I have a 2911 running WAAS Express connected to my ...

Hello,My private network IP is 192.168.x.xAnd I have a  server running on a Public and IP is 182.88.x.x and there are different applications are running and different ports.Can someone help me to create an ACL for giving  access to all ports from my ...

I have a modem DPQ3212.The led DS is amber.The led Links is amber, but flashing.Only one downstream channel is open.My ISP tell me all is OK, but my internet is slow.Please, help me.I need all the leds in green.And excuse my poor english.

Dear Techies, I am facing wierd problem at one of my client office, We have replaced small business router cisco RV042 with Cisco ISR router 2911, in that router we have configured NAT to allow internal user to access internet and port forwarding for...