Routing

Hello,i have 2 X cat6k (1 for users and second for servers) connected to each other via 4 ethernet links point to point. routing protocol is ospf with max-path enabled.there are about 100 useres that need to talk with 8 servers - so i have several di...

Hi all,   Service policy output command is not supporting on Vlan interface of Cisco 2900 Router.I am having one  HWic 4ESW Card and configured VLAN interface. But Service policy output command is not supporting.Same config is supporting in the Cisco...

I have an issue that looks to be cef related.Design is essentially a private L2 cloud to multiple customers. Head end router then creates an encrypted tunnel via a virtual template, and vrf lite.Design runs smooth on a 3945 but with about 10 meg sust...

                   HI all,    Wat will be the default memory and hard disk for SM-SRE-710-K9 and wat will be the maximum support for this module.Regards,Thomas

Hi,My scenario is similar to what has been discussed here: https://supportforums.cisco.com/thread/2067691Two WAN interfaces of Cisco 2921 router connected to 2 ISP leased linesStatic NAT entries on router mapped to web/mail/ftp serversNeed to load-ba...

ADSL line do not activate. Telco Confirmed Like is Okay . They have tested no issue observed. Router replaced but did not help.     Supspecting Firmware not compatible with telco . Not sure how to confirm on this.sh ver Cisco IOS Software, C180X Soft...

Hello Expert,I have three links with three ISPs, each link connect separately to ISPs .... so i used weight and local preference as bgp attributes .... at first i was using three links on service with same attributes for all of them .. then i tried t...

Hi!I need choose a router to interconnect Control Centre with several remote stations, what router model is recommended fot this network? The link subsystem will need to link the equipment that will be installed in the different remote stations. Ther...

I have 4 GB installed in 2951 but only 2 GB show up.  Am I missing something?Total memory size = 4096 MB - DIMM0 = 2048 MB, DIMM1 = 2048 MBCISCO2951/K9 platform with 4194304 Kbytes of main memoryMain memory is configured to 72/72(dimm 0/1) bit mode w...

I am having a problem configuring a VPN connection from a 1721 router to an ASA5520.The router has already been configured, but I have been asked to setup the VPN.I think the issue is because they are using a Loopback interface (which I have never co...

Hi !i have a nat statement : ip nat inside source list VLAN108_NAT interface GigabitEthernet0/1 overloadand i want to change it from interface dependent to a "floating nat" .can i use this ? ip nat pool VLAN_108_NAT_POOL 212.11.55.55 212.11.55.55 pre...

HelloISP provided Internet link over a Wimax Device. The switchport on which the wimax is terminated keeps changing from Orange to Green.Initially we kept speed and duplex auto but no luck then we changed as per wimax team informed to speed 10 duplex...