Routing

We are using DMVPN Phase 3 with OSPF. Some of the remote routers are neighboring with both headends but, some are just neighboring with one. I don't see a difference in the configs. I down the tunnel interface on the remote router that is not neighbo...

Hi First thanks in advance for any help.I installed the cisco 887VAW on my bt infinity line about a month or 2 ago and its worked perfectly unitl i went on holiday for 2 weeks. When i came back I noticed it wouldn't pass web traffic to most domains. ...

Hi, everyoneI have 3 routers connected as follow:R1 -(.34 )--(5.5.128.32/27)--(.33)- R2 ---(.2 )--(5.5.128.0/27)--(.1)--- R3 R2 have pim sparse-mode and it is the AutoRP and Mapping AgentR1 have pim-sparse-mode and the loopback interface is igmp-join...

Hiwhat appens to a route being distributed to EIGRP with this route-maproute-map Redistribicao_BGP permit 20 match ip address 11 set metric 0 -1 0 255 1ThanksAntero

Hi,I've been asked to set one of our statlite offices up with a couple of voip phones, a couple of WAPs and a few control devices and PCs, I only just passed ROUTE so am still quite new to this.I am hoping to use a dsl line and a suitable cisco 800se...

Hi,             I have following scenario - router 2911 connected to 2950 switches with about 80 vlans. How can I limit speed on each of the 79 vlans (to equal % acros all of them) and give vlan 80 lets say 30% of total bandtwith. Since I am new to Q...

I have a backup router scenario for my remote sites I'm trying to build and test.  The remote site router has an IPsec tunnel to an ASA 5510 facilitated via crypto map applied to a fastethernet interface which is attched directly to a DSL modem and g...

Just a scenariorouter 1 and router 2 (isp)router 1 wan ip --101.2.2.1router2(isp) wan ip-  101.2.2.2I have network of 202.x.x.x/24on router1neighbour 101.2.2.2 route-map chic in route-map chic permit 10match ip address prefix-list dafaultset local-pr...

Hi,In general we have installed an analog cameras in many of our branches and remote sites and we want to isolate the business applications traffic from the cameras viewing traffic as the follows:HQ Links:- main link: by default all the branch traffi...

hi all, My requirment is to drop the Internet traffic once the Cisco HWIC 3G backup link will become active(attached) .Because I should allow only Business Critical Data allow through that and others should drop. Here are the config I used. In here I...