Routing

hi, I have network consisting of 6506 as a core switch and 3750E as an access layer switches. My access layer switches are connected in daisy chain.The problem is that when my clients transfer a file from one system to another system the transfer r...

I have a 3750 stack of 4 switches that was installed about 2 years ago. Recently I was doing some work on the switch and realized that I am unable to save the config. I amobviously concerned that if the power fails or the switch reboots I will be rec...

I am trying to allow magic packets from our management servers to client PCs located over routed links.  The management servers are on addresses 172.22.200.54/16 and 172.22.200.63/16They are directly connected to a 6500 to vlan 1 (GI 1/30 and GI 2/14...

Hi,We have 512 link and observe output drops and application timeouts. Link utilization is not very high.When ping with 1500 bytes, it shows output drops and when ping with default packet size, no output drops observed.Service policy also in effect a...

Hello,I have a router 819 with 3G built-in. Are there any manual for how to setup the interface celluar 0 for this router out there? I have Verizon as my 3G provider. Thanks.

Hello everybody.I faced with strange behavior of Cisco 2901.I strat ospf process on router, do some ospf manipulations and than turn off ospf withR1(config)#no router ospf 1But after that when I start to change my config: shut/no shut interfacesI see...

Hi , i am new on buying Cisco ISR series.i was planning to buy cisco 2901 Router.i need to create SITE TO SITE IPSEC VPN on that, i just need to know, when i order router , i need to buy additional SECK9 package?What all i need to tell the seller, i ...

hi i need help i have a question Is there ia a way to change the bgp route-reflector path without changing its client path.

Hello,I'm trying to use a cisco 887VA-SEC-K9 router for a domestic PPPoE DSL (italian NGI DSL) but it doesn't work..No problem with my domestic router.I have another problem: I'm installing cisco-config-pro-exp-k9-2_6-en but it doesen't work. The bro...

Hello,I have setup my cisco 870 for ddns with no-ip.com but it does not work. When i press "show ip ddns update" I get "Update Destination not available" and even i have ddns debug on no messages are showing. The config is: ip ddns update method noip...

I am using DMVPN with EIGRP to provide mostly a backup path to an MPLS network using BGP. However the network is a mixture of sites that are connected to both the MPLS and Internet based DMVPN network and sites that are only connected to the DMVPN n...