Routing

Dear All,I have a Cisco Catalyst 4003 series switch with WS-X4012 supervisor engine installed on it. When I looked at the LED indication of the module, if found it has turned from green to amber which seems there is an issue with this module. Aprecia...

We can not see mac of client on our side some time.interface GigabitEthernet0/1.2361 description Shindler Riyadh encapsulation dot1Q 2361 ip address 77.87.17.129 255.255.255.252 ip broadcast-address 0.0.0.0 rate-limit input 2048000 256000 384000 conf...

good morningi have access switch in my domain hav one vlan missingall vlans appear excpet one vlanwhat is thepossible cause and possible solution regards

good morningi have access switch in my domain hav one vlan missingall vlans appear excpet one vlanwhat is thepossible cause and possible solution regards

Hello, I have two routers. Taupo  router is running RIP version2. Huntly Router is running OSPF. They are  both communicating using Frame Relay.I want to redistribute RIP routes from Taupo into Huntly. I have attached my relevant running-config detai...

Hi guys,Just like it says on the title I was wondering if I could use Cisco GSR12000 router as BRAS to manage clients via PPPoERegards,

I need help on to configurint an IP VLSM scheme and implement it in the following diagram 

HiWhich Syslog server do you suggest for collecting syslog message in network ? on internet there are many and many syslog server and all of them claim their product is the best for all needs and in entreprise level.So I had to create this discussion...

I have a Cisco router connected to a Juniper via T3, and there are periodic bursts of 100's of rx errors on the Cisco side. The salient feature is the CRCs and overruns increase in lockstep but other error counters are 0. The controller always shows ...

Hi I would like to ask assistance regarding QOS issue i'm facing my customer. Currently they have 60Meg BW, and we allot 2048 to their realtime trafic. The problem is that they are seeing drop rates even we if we are not reaching the full capacity of...

I have an issue where my bgp logs are not being sent to a syslog server. I am getting %SYS-5-CONFIG_I: Configured from console by user on vty0 (x.x.x.x), so there is proof logging is working. Howerver, when I do a clear ip bgp A.B.C.D the following a...

Does anyone know why the bandwidth statement on the subinterface would be ignored unless its applied to the main interface? In a head-end setup i may have additional subs and I would think the bandwitch statement on the main int should reflect the ac...