Routing

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Webinar

 
Labels

Forum Posts

Buenas.A ver si alguien puede ayudarme.Estoy configurando el router mediante "cisco professional configurator" ya  que según he leído, no es posible instalar en el 881wr ninguna version de SDM.El problema es, que cuando hago cambios en el AP, al rein...

vdejuan by Level 1
  • 581 Views
  • 1 replies
  • 0 Helpful votes

Hi Expertsi configured the logging parameters on my Cisco asr 1000 , but nothing was sent to my terminal monitorlogging onlogging buffered debugginglogging buffered 5no logging console thendebug ip bgp updateterm monbut nothing appearpls helpjamil

I have an 877W that I want to have ready as a backup to our existing router.  I was able to coopy the config from the new router to the old one, but the new router still had some factory default settings left on it that were conflicting with the new ...

Very basic scenario;f1/0--R1--f0/0----------f0/0--R2--f1/0I wanted to create an mpls encapsulated xconnect between interface f1/0 on both routers (as this is part of an mpls network). I wrestled with this for some time and never got it to work. In th...

jwbensley by Level 1
  • 1249 Views
  • 5 replies
  • 0 Helpful votes

I have a 1921 router with a V.2 T1 wic installed connected to a MPLS circuit.  The circuit is down hard and the CD light is flashing.  We reseated the WIC card and the circuit recovered for about 30 seconds, then went down and CD began flashing again...

mt3368 by Level 1
  • 1710 Views
  • 1 replies
  • 0 Helpful votes

Hi,I have a 7200 router with a 12.2.(46a) IOS and I am trying to activate Netflow on a subinterface. From the documentation of Cisco, I should be able to do it since the ios 12.2.(14)S but the command is unavailable.http://www.cisco.com/en/US/docs/io...

Hi, I recently inhereted a partially completed project from another engineer which I need to finish but can't quite figure out how to accomplish properly. The setup goes like this... I have two sites, Berk (The HQ Office) and Sac (The Remote Office)....

Dear All,I have a mistirious problem in OSPF routing. please help me fixing this issue.RA and RB is directly connected with Radio Link which is advertised with OSPF.Sometimes link between RA and RB goes unreachable but link is fine..Another Hint: whe...

Hi           Can anyone help me out with thisCan we assign two public IP's for a single router interface & if yes then both the IP address should be in working condition parallely.  If yes give me a description and set of commands in a step by step o...

Resolved! confreg parameters

I referenced my confreg examples fromhttp://www.cisco.com/en/US/products/hw/routers/ps133/products_tech_note09186a008022493f.shtmlMy question is, why is 0x2102 the default if you can easily use 0x3922 instead?The benefit being that your console seria...

Review Cisco Networking for a $25 gift card