Routing

Hi,Headoffice:In my headoffice there are two cisco routers.one router is connected with bsnl mpls link and another router is connected with Tata mpls link.In bsnl 3845 router Gig0/0 is configured as local Lan 10.10.30.100/22 and Gig0/1 as MPLS link(8...

Hi All,I am trying to convert QOS policy on 6500 CAT to IOS as below,1-getting error when try to apply on  interface.2-How can I apply both into one plicy map because IOS convertor puts into two policy maps.Please can any one check and advise any alt...

Hi,I have this weird scenario whereby my customer wanted 3 VLANs and each VLANs should have the same IP.PC1 (192.168.1.2/24) in VLAN1.PC2 (192.168.1.2/24) in VLAN2.PC3 (192.168.1.2/24) in VLAN3.Is that even possible?

All,First off, I have been using Cisco IOS routers for many years.  I have a 1941W that is giving me fits.  I have a simple configuration with Gig0/0 being the WAN link and Gig0/1 being the LAN link.  (Don't get me started on the AP.....I may buy a L...

Hi EveryoneIm planning to add a cisco switch to my network. A friend of mind told me to be on my guard (lol) because he had once done this before and the network was down.Does this really happen? If yes why? And what precautions should i take before ...

Hello all, I have the following configs for NAT in a Cisco2650XM:ip nat inside source route-map nonat interface Serial0/0 overloadroute-map nonat permit 10 match ip address nonatip access-list extended nonatpermit 192.168.85.0 0.0.0.255 anyinterface ...

I'm working on my cisco lab.  Every device is plugged in to my switch (computer, router, firewall).  Whenever I telnet from my computer direct to my router, it works for a second and then disconnects.  I cant then reconnect.  If I telnet to my switch...

I used to have a 877w in the same place and same setup as my current 887, this time though the DMT Bits Per Bin just will not populate on ADSL2+ altough it did work when it sync ADSL1 (same line/DSLAM, just came up ADSL for some reason).Any Ideas? It...

I have a 3550 switch that I am trying to upgrade the IOS on.I am trying to copy to a TFTP server.I am receiving a socket error.I saw that this can be fixed withSwitch#config tEnter configuration commands, one per line.  End with CNTL/Z.Switch(config)...

Hi Guys,I have the below network. Here is the senario.OSPF process 1000Firewall is in area 2 and 1 and 0Switch1 is in area 2 and 1 (not 0)Internal switch is in area 1 onlyRouter1 is in area2 onlyAs you see I want to transfer the default route from Ro...