Routing

Team,i am stuck on some design issues, attached is diagram, in Red enclosed area,i am acting as a Partner in this case, so bottom area is mine.There are two main requirements.1-Partners will run an Interior Gateway Protocol (IGP) of their choice whic...

Hello ,       I have a internet router 2921  .my isp is providing 100 mbps internet link with static public ip network .I am using a default static route to the isp wan ip .I am planning to  upgrade 100 mbps to 114 mbps .Unfortunately my isp doesnt  ...

There is a router with three OSPF neighbors.  Recently, all routes that would use one particular neighbor were removed from the routing table.  The OSPF neighborship stayed up, but the routes were gone.  All the OSPF database info was still there, bu...

Got this shared outbound 1 Mbps satellite link used by two remotes sites, inbound uplink is fixed dedicated 512Kbps to each.They both connect to core using ipsec/gre tunnels through the same physical gigabit ethernet interface.What I am trying to acc...

I want to distribute some static routes to an OSPF neighbor on the same subnet, but only that one neighbor--I have two other neighbor relationships. Is there a way to redistribute static routes to only one neighbor--with a route-map maybe, or another...

i have an asr-1001 with sfp-ge-t gbics. i tried to use those same gbics in my asr-1002 - they don't fit.  do the asr-1001 and asr-1002 not support the same model of gbics????where can i get the list of gbics supported for each?

Hello,I wanted to know which is your recommendation for a PPPoE server that should manage 600 or 1000 PPPoE sessions. I don't know if a ISR G2 could manage such number of sessions or which router series should I consider. Perhaps the ASR series route...

We have a WAN router that has two serial ports with very high number Fast Switched packets.I am just wondering, is this a problem? why not CEF doing it?thansk,Han1# sh int s1/0 switchingSerial1/0           Throttle count          0                   ...

I am using ip sla with ios currently in c1900 and 1800 series isr's fine.  They currently will failover when an icmp echo response is not recieved from the isp gateway after a certain amount of time.  I am wanting to know if they can be configured to...

Hi experts, I just installed two of the HWIC-1GE-SFP cards in the CISCO3945 router but they are not recognized... I don't see any messages on the console output. I don't see them in the "show diag" command. I don't see new ports in the "show run" eit...

Permitir acceso a paginas bancarias HTTPS con router RV042 Buenos dias, mi pregunta es la siguiente.Tengo un router RV042 y posee dos conexiones a internet. cuando conecto las dos conexiones al router y configuro el mismo comobalanceador de carga, no...

Hello,EIGRP key chain authentication is configured on R1 and R2. Case 1.there is no send and accept timers configured on any of the routers Case 2. Send timer is configured on one router and Accept on another rouer Case 3: Send timer  is configured o...

I have this configuration in a Router 2800. I need to know what functionality is first applied: "service policy input" or  "crypto ipsec".interface FastEthernet0/0 description Conexion LAN ip address 10.33.84.1 255.255.255.0 speed 100 full-duplex cry...

Hi Folks,Have a bit of a odd problem that I hope you can help with.I have four routers that are redistributing a static route in to BGP. The static route points to an IP address as the next hop.When I look in the BGP table three of the routers show t...