Routing

Hi Ihave scenario where i have  172.16.16.12 its for source will translate to 94.56.x.x  and if any traffci comming from internet to 94.56.X.x  it translate to 172.16.16.11Kinldy keep in mind 94.56.X.X should be same at the time of source naating an...

Hi all,I am trying to configure a Hub and Spoke frame relay network with a mix of the "Frame-Relay map IP" command and the "Frame-Relay interface-dlci" and have a problem sending routing updates. I know that by default a frame-relay network dose not ...

Hi,My query is whether cisco 2900 (specifically 2951) will support more than 2 Mbps link (i.e either through ethernet or serial)?

Hi,Can someone please tell me what "locald process" does in cisco IOS XR ?ThanksAbhishek

Hello .I have a LAN built by Cisco Router CISCO881-K9. We need to see if a particular site is visited by the local network. For example, there are 20 computers in the LAN. How can i understand if someone visited for example google.de. Is  it possible...

Hi alli am new to networking so i need help from u.guyzzi want to configure the router for internet access for hoststhis is the my pub ip x.x.x.174 and mask 255.255.255.252 this is isp given subnetmaskinternal ip range is x.x.x.20-x.x.x.254what i hav...

After spending almost two days on trying to fix this an issue with getting traffic to flow through a site-to-site VPN. I am reaching out to see if anyone can shed some light on the creation of Site to Site VPN's using Cisco 1941W routers and what I h...

Hi, we have 55 of the 1841 routers here, and one of them always boots to ROMMON from a very cold (down 1 hour or more) start.  The image on all 55 is c1841-ipbasek9-mz.124-24.T4.bin.  32 MB Cisco brand flash.  Here's what's been done thus far:In ROMM...

Hi All,Attached is packet capture of the BGP on 192.168.10.1 router.The the config of the 192.168.10.1 (Packet number 23)  router bgp 400 bgp router-id 192.168.10.1 bgp log-neighbor-changes bgp default local-preference 150 network 10.0.0.0/15 network...

Hi Guys.I encountered this problem with cisco 870 atm interface. I applied service-policy output, its being accepted but when you do a show run interface, it's not there. is this a bug?IOS version used is: c870-advipservicesk9-mz.124-15.T11.bin

All,I have banged my head against the wall for too long trying to figure out how to force traffic back out the same interface from whence it entered.  Review the following topology.  Any suggestions are welcome and appreciated.Internet ---> ASA 5510 ...

Hi Experts/FriendsI am facing a weird problem for which I am trying to find an answer but in vain. What's happening is that we have about 70 sites(spoke) connected over MPLS to HO (hub) using IPSec/GRE Tunnels, HO WAN router 2800 is connected using V...