Hello Chaps,I got a guest vlan 193 ... i put acl's on vlans before no worries when i do it to this one if i put for example (extended rule deny ip 10.193.0.0 0.0.255.255 10.1.0.102 0.0.0.0.) 10.1.0.102 is a file server it blocks the ping but also...
I have a cisco 800 series router which I configured months back with username and password. Now I wanted to use it recently but cannot remember my username or password.I decided to use rommon to reset the password and during bootup, i hit ctrl+break ...
OK, here is issue:I have 2 sites, and each has a connection to the Internet. Both sites have an Internet router with an ASA 5510 behind it.Site A has a DMZ off the ASA with a public address space. Let's call it 12.220.7.192 /26The two sites are conne...
Hi, I have got a l2 link of 512 kbps from two different ISP. I want to aggegrate the bandwidth of this connection so that I can feel like having 1 mbps connection. I am not actually talking about load balancing, but bandwidth/link aggegration. Can we...
Hi, I have got a router at branch having three interface card on it. I tried to give example as follows: Main Server IP address: 192.168.11.5In the central router I have routed as: ip route 10.10.20.20 255.255.255.255 10.10.11.20ip route 10.10.20.30...
I have a 3750 acting as my WAN router connected to our MPLS provider via ethernet. For a couple days my inbound bandwidth has been completely saturated at 20Mbs (the speed of my link). I know this model of switch does not support netflow, but is th...
Hello everyone,About one week, I have received the log's below which I am not able to identify any reference to protocols or services active in my router's, log files are:Oct 17 08:16:49.240 GMT-3: %Card in slot 8 has been OIR removed by ORFS..Oct 1...
Hi allI'm trying to set up an 1801 router with two WAN interfaces, fastethernet0 and fastethernet1. On the LAN side, I have two subnets. One subnet's internet traffic should be routed over fastethernet0, the other over fastethernet1.I've setup some r...
Hi everyone,I am really confused about using bgp and ospf/eigrp(igp) together. Why do we have to use both protocols at the same time. if we can use ospf or eigrp with isp, why do we have to configure bgp then. If isp is using igp , then can't we just...
Sorry this is a dumb question, but my manager ordered some Cisco X2-10GB-LR in hopes of having a 10GB uplink between two buildings. We put those modules on the switch and we are getting link flap errors, then the ports goes into err-disabled state. I...
Here's my network scheme in Packet Tracer:How do I do the routing in CLI to connect those three routers?Note that the routers are in different cities. Any videos or tutorials I can follow?Thanks.
Is it possible to run ospf over an ipsec tunnel between an ASA and a router? I can create tunnel interfaces on the router, but the ASA doesn't support it so I don't think it's possible. I'd be terminating the tunnels between the devices and not throu...
Hi BGP Experts,I am seeing a behaviour where the as-path prepend allows the cisco router to advertise a route with as-path where the originating AS is changed after applying route-map . As per my understanding the originating AS should not be changed...
Hello All:I am slowley getting this router configured........I am up and running, Thanks to this group. Traffic from All nodes inside can go outside. My next step is to configure traffic coming in to go to my server. I have Web, FTP, SMTP and POP ...
