Routing

We have two sites, A (central office) and B (remote), connected via a transparent LAN connection with ethernet handoff to our 2800 routers. They are EIGRP neighbors. I upgraded the IOS for site A to a newer T release and reloaded, but an adjacency ne...

Hi everyone,I just update my cisco 7609 to Version 12.2(33)SRD6. I encounter a strange problem with this version, everytime i change BGP policy ( input or output ) this will take affect immediately without "clear ip bgp neighbor <address> soft". Are ...

Hello, I want to use GLBP and have a question.  I have two ISPs that the two routers will be independently setup on, however, one router will have an extra connection for the Fiber links we have for 3 smaller remote offices.  So One router will have ...

Hello allIn datasheets of routers/switches, I noticed that performance is defined in two termsOne with a unit of packet per seconds (pps) and other one is bits per secI found serveral terms for these 2 units as system capacity, forwarding capacity, t...

Dear all,What is this command use for in switch ? What will happen will I enable or disable it?spanning-tree optimize bpdu transmission

Seems like I spend more and more time in here (Cisco Forums)....I was talking to a guy today that was trying to help me link my three networks together, so each is sperate but able to talk to each other.  Right now I have them all connect via my ASA,...

Hi,we are doing class map using access group. that is we pick up required IP addresses, put it into access-list and associate that access-list with class-map and then assign dhcp value to that class-map.my question here is:is that a way that perticul...

I am running an 877W in the home that for the most part works fine, however after being connected for a variable amount of time I partially loose my DSL connection. Line sync stays up, but the traffic is lost.A shut/no sut of the atm or dialer interf...

Whenever I bootup a new Cisco 881G, the router hanges at the following location and never moves pass it.:%CISCO800-2-MODEM_UP: Cellular0 modem is now UP.I have left it setting there overnight with no change.I've tried to reset the config by pressing ...

What is the diffrence between the following:Int GI0/0  ip address 10.10.10.1 255.255.255.0  duplex full  speed 1000  negotiation autoInt GI0/0  ip address 10.10.10.1 255.255.255.0   duplex full  speed 1000(Are the two configurations above the same?)I...

Hi,I've been working on some tweaks to our BGP setup, and wondered if anyone else could confirm some behaviour I've noticed.When using the aggregate-address command with a suppress-map, it would seem that if you match prefixes to be suppressed using ...

Hi,as per attached topology where exactly we can place our OSPF Area-0  , basically in case of a single MPLS provider we can make it as SUPER OSPF AREA , but what will happen in case we have two or more MPLS links from different ISP's.Vijay