Routing

Hello, ServiceProvider community is a little bit "slow"   - I'd like to open discussion here as well, plese have a look http://supportforums.cisco.com/thread/2117637may be someone have an idea.Best Regards,Konstantin

Hi.We have a new ASR 1002 router in which UnconfiguredIPv4Fia drops counter is increasing continously. Anybody could help me to troubleshoot the reason of this kind of drops? I have tried to look for tech info about it, but I have found nothing.REMOT...

Frnds,I am using 3550 with  c3550-ipservicesk9-mz.122-44.SE6.bin. Have successfully run ipv6  commands on global and interface, however getting below error while  configuring "ipv6 router ospf 1" :SW1(config)#ipv6 router ospf 1 % Failed to create ro...

How to enable GUI for a Cisco 1841?

Hi All,First off i am sorry if i am posting it in the wrong forum.I have a couple of cisco devices and exploring possibilities of starting a small teaching institute.For this i would need your inputs on various lab scenarios that is possible from the...

Hello,I seem to be having an issue with Policy Based Routing on a Dialer interface.  I have the following two setups:A.  Cisco router with ADSL WIC - relevant configuration informationinterface ATM0/0/0  no ip address  no atm ilmi-keepalive  pvc 0/35...

I have DSCP marked traffic coming into my network via a WAN link thru an ASA and then routed.  I have a requirement to return reply traffic back via the same return route with the same DSCP marking.I cannot use IP address or port no to identify the t...

Hi, We are trying to get a 1 Gig Link up and running on MM fibre between two sites seperated by a mile distance. We managed to get the line protocol up on both the sides but fails to carry traffic.Please find the SFP Details,interface config and SP ...

Hi, I am having issue on my 3750G gig interface, it is not passing data more than 200M.Some how its giving me lots of input Pause on both sides,can some one explain if there is congesstion issue,do I need to enable flow control on both sides?regards,...

Hello all,I wonder if someone could help me on a little matter I have. I would like to configure an 877w I just bought. It's connecting to a UK ADSL2+ link.I'm a penetration tester and I want to put the Cisco router in front of my existing firewall w...

Hello,If anyone can help me with this please:Generaly speaking, one router R is connected to 2 different ISPs via BGP and receive full BGP table1) How much memory this router R needs? Does it need to store 2 BGP tables ( 2 x 300.000 routes) plus rout...

Hello,I'm trying to figure out if the multi-layer Route-Reflector topology would work for me. Let say we have 2 Route-reflectors RC-RR1 and RC-R2 and all other router are their reflect-clients. Now I'm getting a new router RC-.E001 and would like to ...