Routing

To anyoneI want to make a Netgear wireless AP for Guest users in our office to only have WWW access.I was told by Cisco support to create another VLAN2 and configure the FE1 on the Cisco 891 as a trunk and put the Netgear AP on the VLAN2.Here is the ...

Greetings! I seem to have an issue with access across subnets over my VPN when using an ASA 5505 at my corporate office and an 881W router at my remote office. Here's the scenario... At my home office, I have an ASA 5505 with VLAN 1 on a 172.24.0.0/1...

Like the heading says, the interface is dropping output but the queues dont show as many drops.  Are the class based queues nested inside one overall queue for the interface?Houston#sh queueing inter s 1/0Interface Serial1/0 queueing strategy: fair  ...

Hello,I have one scenario. One end is using Cisco router and the other end using Juniper router have been configured eBGP Multihoming using loopback IP. At each router, two interface have been configured and both static route has been pointing to the...

Hi,I have some branch routers. I would like to go with BGP with the ISP & wish to have 2 links working in Primary & Secondary setup...Can i achieve this using weight attribute??

Hi,I had an older Linksys RV042 working perfectly until it blew up on me after 5 years of faithful service.  This new 'Cisco' with v4.0.0.07-tm firmware appears to be a dramatic step backwards - I'm tempted to call it a heap of junk!!!1. The 'Smart L...

Hi all,I would very appreciate if you can point me out to Cisco CLI command which begins OSPF Graceful Restart after all GR parameters are set.Is there "some" Graceful" reset/reboot?Thanks,Dmitry Petrunin

I am trying to upgrade CP Express to 2.5 and after the upgrade I bring up the webpage to login and I am prompted for my credentials, I enter them and I am authenticated.  However the CP Express home page never loads.  Has anyone ran nto this before a...

Hi all.I'd like to know what it is means regarding regex ' .* ' . To make sure, I wanna do cross-check.and If I know the specific AS number when I type down as show ip bgp. How can I find out the management ip address of that AS number?

hi need some help with static routes.i have 2 connections a single T1 for voip traffic only and a DSL line for data traffic.the dsl was migrated to a 2811 with out any issues now comes the time to move the T1 over.on the T1 side I am able to ping the...