Hello,On a RV340 Series Router, how would it be configured to enable packet capture of all WAN / LAN packets?Router documentation is very basic, repeating the on screen U about everything including port mirror function, and is not clear about how to ...
Forum Posts
Hello, everyone, I have this scenario where a Cisco 2901 Router configured as following :Building configuration...Current configuration : 2428 bytes!! Last configuration change at 15:04:22 UTC Sat Nov 19 2022version 15.2service timestamps debug datet...
Resolved! Cisco 860 Series Routing Help
Good Morning, I am seeing issues with my newly bought Cisco 867VAE-K9 in that I cannot ping outbound from a device inside the network to outside. I can verify the following: PPP Details are correctThe router can ping outbound from CLIRouting externa...
Resolved! Static Routing
If we make dual static routing with same destination and same cost, will the traffic load balance to both gateway?
Attached topology. All routers interfaces are part of the same /24 & area 0. 1.1.1.1/32 is adv. from both R1 & R4. Is there a way I can influence R5 to prefer R1 over R4?
Hi,I just have a quick question. In this scenario, at which points does multicast copy/duplicate the packets to send to the host in the group? Does it replicate at switch 1 and 2? Or since SW3 is only trunked to SW2 and how no layer 3 interfaces, doe...
How is it even possible that a company as big as CISCO does not have CAD drawings of their products?We know you are not building them with Visio. You make it very difficult for use to place your products in our enclosures.
1.Reason that we see High CPU utilization issue for router and switches.commands --SH process cpu ? like that right?2.Reason that we see High memory utilization issue for router and switches.here when we see High memory Utilization issue then is it r...
Resolved! Routing router ipv6
Hello, As part of my project, I have to carry out a routing between my routers in IPV6 I made it in ipv4 with dynamic routing unfortunately I can't reproduce it in IPV6Here is my dynamic configuration in ipv4: confeigrp 100 routerno auto-summarize...
Hello,As part of my project, I have to perform ipv6 routing between all the router, I did the same thing for ipv4 I managed to do ipv4 routing thanks to a similar post but for ipv6 It's the first time I've done it and I don't know if I started on a g...
Are the GS7000 i Nodes going EOL?
Resolved! GRE over BGP
I have 3 routers R1, R2, R3 connected within same AS (IBGP).I would like to establish a GRE tunnel between R1 and R3, can someone share me some guide please.
I am tasked with configuring the DHCP server to auto assign IPs to each department. Each department is in its own VLAN. The only IPs that are being assigned right now are 169.x.x.x and I am not sure why. Can anybody help?
hi ciscokindly, why i need this command , as i know when i enable bgp additinal path in RR by following command for example : router bgp 100 ( RR )address-family (ipv4/6,vpnv4,6) unicastbgp additional-path send recieve bgp additional-path select ...
Resolved! VRF export with nexthop filter
Hi guys, I try to attach an extended community to a prefix selected by its next-hop While this works perfectly with a route-map attached to a BGP neighbor, when trying to use it as an export map the router attaches the extended community to all prefi...
