Routing

Can anyone here confirm for me that a regular T1 will or will not give you 1.5 up and down, while a bonded T1 is 3.0 Mbps which is 1.5 up and down.Thanks,BRSent from Cisco Technical Support iPad App

To anyoneI am switching out our old WRVS4400 router to the Cisco 891.having a problem configuring the Cisco 891 router. I changed the VLAN port on the 891 from 10.10.10.1 to 192.168.2.1 and the ip address saves but when I try to rediscover it through...

Hello,Has anyone implemented and is it possible to setup Cisco Webex using Multicast.We have a Webex account and about 600 of our remote locations participate into a Webex session every Thursday. These sites conenct through a Hub Datacenter and consu...

hi! i;ve 2x L3 switch (hsrp) connected to one 28xx router(r1), and that router is connected to 2 routers(r2, r3). I plan to run ospf in the 2x L3 switch. Pls provide me with a guideline on how the route shd be for the r1, r2 and r3 routers. Do i need...

Got a little bit of a weird issue.  Setting up a router to be added to our mpls network.    using eigrp.  we usually use the no auto-summary command so that the subnet masks are broadcast in the routes.  However, every time i add the no auto-summary ...

For ASR1000 to support 4M routes, RP2 must be used.  Does anyone know1) RP2 need to have 16GB memory in order to support 4M routes?2) Need to use ESP20/40 together with RP2?3) If RP2 + ESP10, supporting route table size down to 1M?4) 4M routes is sha...

Hi All,I have one ASR 1002 router and one GSR router. when i insert  SFP-OC48-IR1 module with GSR and connect 100 Mb link that comming from MUX then the GSR port is up but when the link is connect with ASR with same module the port not going up.i had...

Hi,Could you help me with ASA5510 configuration, I would like to know if it is possible (and how) to forward traffic received on WAN port of the first ASA to the server in LAN on the other side of VPN tunnel:Internet (IP 85.128.50.x) – ASA5510 (192.1...

I am trying to install VWIC2-1MFT-T1/E1 into c2600 router w IOS C2600 Software (C2600-I-M), Version 12.3(26)with 28672K/4096K bytes of memoryIt is not recognized? Do I need another version of IOS?

I'm getting all of the following errors on three different 56K circuits - all are at the same location and all likely riding the same higher level facilities when handing off from teh LEC to our provider.  The building maintenace supervisor has told ...

Getting message, cannot open "flash:" on 1841 evdo router, how do I reinstall flash? I am currently consoled into the router, the prompt is coming up as rommon 1>