Routing

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Labels

Forum Posts

Hi,I am trying to direct nearly all traffic to WAN1, which is my high-throughput Broadstripe cable connection. I would like the traffic from certain online games to use only WAN2, which is my low-latency Speakeasy DSL.After a few days of messing arou...

ThaLunatik by Beginner
  • 1839 Views
  • 2 replies
  • 0 Helpful votes

My original question was answered to remove certain Vlans from the 6500 and add it a new 3750 switch.  The traffic from the 3750 would only access the 6509 network when needed.  The inter vlan routing ould be done by the 3750 instead of the 6500.  I ...

I understand how to create ACLs, class-maps, policy-maps and use service-policy [input|output| to apply the QoSto a specific interface etc etc. But I'm having a bit if a problem understanding how QoS actually goes into effect.I'm assuming let's say, ...

I have enabled ip accounting on a Cisco 7613 router interface and ip account-threshold in global configuration.  When I perform the "show ip accounting" command the table is empty!  I can see that traffic is flowing across the interface, but my accou...

Trying to telnet from router to router across frame relay (details below). Can ping OK but when I telnet it gets as far as telling me the session is open but I never get prompted for a password. I hit enter and every key combination I can think of. I...

g-fadie by Beginner
  • 3131 Views
  • 2 replies
  • 0 Helpful votes

I wonder if anyone can assist:We are changing ISP, and for a short period have two lines, each with a 2811.   We use NAT translating a number of IP addresses onto one internally addressed web server. Unfortunatly I can't transition all the sites to t...

we're upgrading some of the junipers and are torn between the XR12000 and CRS.whom has experience from both? is the XR12000 too much of a risk to handle the full table?it should be able to handle the full internet routing table plus more.should we ju...

Robert Ho by Beginner
  • 620 Views
  • 3 replies
  • 0 Helpful votes

Hi,I am trying to configure etherchannel (LACP) between Cisco 6509 switch (which is running) vss and Hp servers.here is my configuration, and my problem is why all the bundled interfaces are in  I - stand-alone state ???interface Port-channel10 descr...

Hello,I have a 2801 doing pbr routing by source ip to 4 different gateways.interface FastEthernet0/0 description lan bandwidth 100000 ip address 10.1.10.1 255.255.255.0 ip nat inside ip route-cache flow ip policy route-map inet duplex auto speed auto...

Hi,I'm setting up three VSS system with OSPF as IGP and MPLS ontop.      |--------------mpls--------------|   --vss|--ospf--|vss|--ospf--|vss--mp-bgp|----------(P)-----------|mp-bgpIn normal operation the setup work as expected with VRF's, traffic is...