Routing

Has anyone else hit the 32 interface nbar limit on an ASR? Our ASR1002 ESP5 is now grumbling:%NBAR-4-STILE_MAX_PD_INTF: NBAR protocol-discovery is enabled on maximum number of interfaces (32) supported by this platformThe questions which come to mind...

morning/afternoonDoes anyone know if you can create a crypto sec tunnel on a 3650x switch?CheersMarc

Anyone seeing strange SIP behaviour with an ASR1K in the packet path EVEN THOUGH it is supposed to just be routing packets? I'm NOT talking about using the ASR1K as an SBC or NAT ALG for Hosted NAT traversal. Just having the packets pass through the ...

Hi,Imagine organization has about 300 partners. Currently data center has 100 Cisco 1800 routers to accept P2P connections for each partner.Now organization proposal is:- Use MPLS and use an extranet network. Advertise a certain unique route to each ...

Hi, I am running GRE Tunnel in Hub and Spoke with OSPF. All branches connected to Hub with MPLS layer 3 cloud. But few times users complain about the network disconnection for outlook and other applications. Now one branch users continously complain ...

Hello,I am trying to configure the NAT to be able to ping from  hosts placed in  Outside network to Inside networkand also hosts placed in inside network should be reachable to outside hosts  .This entire scenario is for Private network  connecting t...

How do we control eigrp route advertisement in a multipoint GRE Tunne. On static GRE+IPSec tunnels we can associate distribute-list to a particular tunnel and filter out routes to particular site. How do we do that in DMVPN network.

Two questions here:I have used the following basic configuration to do rate limiting on a vlan interface on a 6509:access-list 100 permit ip any anyclass-map match-all ratelimit  match access-group 100policy-map ratelimit-10Mb  class ratelimit   poli...

Hi All,I have a customer router(1801) on which i am running a 2meg Ethernet LL to the web connected to fa0 and also an ADSL for backup on ATM0 Dialer1. I am planning to use IP SLA in conjunction with floating static routes to provide ADSL failover. T...

Hi All,We have 10 MB itnternet link at one of our DMVPN spoke site which is connected to Hub site (20 MB link)When I ran "iperf" test I found that we are getting 1.5 MB which is not even closer to the actual speed.The router we have at spoke site is ...

Hello,I have this topology in part of my networ:k Cisco7200---Cisco6500---Cisco3560---LAN1                        |                 Cisco3560                        |                     LAN2All devices are interconected via optical 1Gb/s links. Ther...