Buy or Renew
Buy or Renew

Routing

cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation

Labels

Forum Posts

Start a conversation

Cisco 2911 - Dialer Interface - No Connection

Hi All - having some issues with a configuration using a Dialer interface. The interface comes up and the VPN tunnel comes up, but cannot access any network resources or the Internet. Was hoping someone could have a look at my config and provide some...

Manage an 891 router from WAN

Is it safe to manage an 891 router across the Internet using Cisco Configuration Professional 2.4?  If so, a few pointers on enabling and configuring it would be appreciated.  If not, I assume setting up a VPN to the router then using CCP across the ...

smoore by • Level 1
  • 307 Views
  • 1 replies
  • 0 Helpful votes

Resolved! OSPF not advertising learned routes

We are in process of migrating our entire MPLS connected network from one provider to another. In our datacenter, we have a link to both MPLS networks and will be the gateway between the two until we're fully migrated. We run OSPF between us and each...

Maybe a routing table entry?

I have a system that has everything on the managment network 172.16.1.0 network gateway 172.16.1.1. I have connected to the system a small Buisness router on the same network but with a gateway 172.16.1.70, It connects to another small business route...

Resolved! 7204 router RAIDUS issue

I was attempting to setup our 7204 Cisco router to use RADIUS for authentication via the AAA commands. I must have messed up when configuring it as it comes up via TELNET asking for a username and password but doesn't take my AD credentials. How migh...

Resolved! BGP always overides OSPF

I have a network with various remote siteswith dual connections into each (BT is the ISP)The primary link is over an MPLS and work s fine alone using OSPF.The secondary link is an ADSL link using BGP and is redistributed into OSPF using prefix lists ...

GRE Tunnel

HiGRE Over IPSEC is configured on a point-to-point link. What is the maximum bandwidth supported by GRE Tunnel.The point-to-point link is 10MB, can I limit the transmit and receive bandwidth on the GRE Tunnel.The Router is C3845-ADVSECURITYK9-M), Ver...

OSPF over eBGP question

I have two routers in two seperate AS's.RtrA advertises multiple routes via eBGP to RtrB.RtrB will learn these route via eBGP.There is one route that will be learned via eBGP and also OSPF. I know that the eBGP route will be preferred on this router ...

Resolved! GRE Tunnel through firewall performing PAT

Hey all,I have the following topology:| Router A |------------{ Internet }----------< Firewall performing PAT >----| Router B |Router A has a public IP address facing the internet.  Router B has private IP addressing and is being PATed behind a firew...

Load more