Routing

Dears good morning!I have a Cisco 7506 end cpu utilization from my VIP 0 is going to 100%. The biggest traffic from my interface is aroud 100 Mbps and my bandwdth is 1000Mbps. Who know what could happend?    645564456507078208709901954556655594010249...

I have two internet routers with a connection to a different ISP on each.  I want to route a specific subnet to ISP1.  I want to route this subnet to ISP2 if ISP1 fails.  I am receiving the BGP routes from both ISP's.  How can I do this?

I have a 3750-X and I am trying to apply a port ACL to protect a server.Port 17 has a server plugged into it that I am trying to protect and allow only two hosts to communicate with it. So I do the following:access-list 17 permit xxx.xxx.xxx.1access-...

Dear friends,I wanted to config 5 routers with static routeing in a serial, please configure the below ipsRouter A connected to Router B, Router B Connected to Router C, Router C Connected to Router D and Router D connected to Router E  A RouterFa 0/...

Hello all,I've got a bit of a problem, and I'm hoping someone else has some experience with this.  My client uses a metro ethernet solution to connect to local branches.  The metro ethernet circuit is delivered on a Gigabit interface.  However, the i...

Hi,I have created a username and password with command username cisco privi 15 pass cisco. when i telnet to switch it ask me for enable secret password??????  though  i have specified a privi level 15 to a user.Switch is authenticating with ACS and i...

Hi All, I am planning to deploy QoS across my WAN for bandwidth management. I have 4 type of classes including the default class. Class A should have 35 %, Class B have 25%, Class C should have 15% and class default should have 25% of bandwidth at th...

First, if this is in the wrong area, please let me know and I will repost it in the right place.I am planning on implementing a metro ethernet circuit to replace a more expensive circuit to connect my office and data center.  This circuit will be con...

     Hello.I have a Cisco 2811 router with two HWIC-ADSL cards configured for dsl connection. I have two lines from the same ISP and i am load balancing between them. I have created a couple of SLA's to check the state of the connections and add to t...

This is kind of crazy, but is it possible to connect wire pairs between two locations (ordered from local telco) if we only have 2 wires (1 set of cable pairs) rather than 4 wires (2 sets of cable pairs)? If we had 4 wires, we could use T1 WICs but w...

Greetings,I am trying to roll out a new internet router.  The problem I am faced with is the LEC only supports VLAN 1227 and greater, specifically they are assigning me VLAN 2528. I am able to create the sub-interface and setup dot1q encapsulation fo...

Guys, hope you can help...I've got a /23 LAN subnet which i need to route out to a carrier in different ways...192.168.0.0/23 is the LAN Subnet but when it comes in on the HSRP active i need to tell that active router that if the traffic is from the ...