Routing

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Webinar

 
Labels

Forum Posts

I have two data centers that have a one gig fiber link between both of the cores that the data centers (3750's) we run eigrp in our network. At data center 1 i have a 7206 with a 100MB sprint mpls link that runs BGP between it and our remote sites. I...

I have following set upRtr A||Rtr B----------Rtr C  AS1|                  ||                  |Rtr D----------Rtr E  AS2||Rtr F||144.14 network.Rtr B & Rtr C are using IBGP in AS 1Rtr D & Rtr E are using IBGP in AS2Rtr B & Rtr D are using EBGPRtr C &...

Need a router and switch for 5 offices. The main office will have 2 internal servers and a webserver. 4 remote offices will just have a file and print server. Each office has less then 20 workstations.  Need wired ports for the workstations, servers,...

I am setting up 2x6509s to run VSS. The IOS coming with the boxes are 12.2(33).SXI3. With this IOS I am running into the bug CSCtc41114 (SSH connections fail to the switch). I am looking into upgrading the IOS to 12.2(33).SXI4a. I notices there are 2...

joe.ho by Level 1
  • 1324 Views
  • 2 replies
  • 0 Helpful votes

This was written by some one else, just trying to get a better understanding..Please help me break this config down and how it works..This is on a 2821 using vrfclass-map match-all cos-map-pre-vo-1 match ip precedence 5policy-map cos-po2-ifx-mfr1-140...

jonesm111 by Level 1
  • 487 Views
  • 1 replies
  • 0 Helpful votes

I have two Cisco 2901 ISR's with a site to site VPN setup...I can telnet into devices on the other side, ping units on the other side... but when I try and use a web interface no dice... I will get prompted for login on some devices then... nothing.....

tedtucker by Level 1
  • 848 Views
  • 1 replies
  • 0 Helpful votes

Dear all,Call manager-publisher went down due to some reason and subscriber came up automaticaly .But some ip phones didnot work with subscriber.can any body help me to find out the reason?/thx

I have 2 bgp routers multihomed to 2 diff isp both sending def route only. I have a ASA-FW behind the BGP routers. I setup bgp local pref and as-prepend so that symmetrical routing go to ISP#1. I currently have hsrp but would prefer to migrate to ano...

aamercado by Level 4
  • 954 Views
  • 3 replies
  • 0 Helpful votes

Any help with this would be appreciated.For the purposes of this question I have two sites, each site has an OC3  to an MPLS cloud. Each MPLS router is running BGP and EIGRP. I'm  redistributing EIGRP into BGP and BGP into EIGRP. Also at each site is...

kmelchior by Level 1
  • 10655 Views
  • 7 replies
  • 0 Helpful votes

What is the best method to use when connecting a router to your core switch?  Should I put the switch port in a vlan where the IP of the router interface is or should the port not be a switchport and give it an IP?I know both methods will work but I ...

Hi,I'm configuring 2921 router and connected to network, it can't ping any of the devices in our network but other hosts can telnet into it. can't telnet/ping it from any other cisco router/switch into the network.following is the configuration:Route...

gavin han by Level 1
  • 1124 Views
  • 3 replies
  • 0 Helpful votes
Review Cisco Networking for a $25 gift card