Routing

Hi Guys,I have a Cisco 2951 terminating my VPN's and I need my  VPN clients to access a public ip address but have the source address of  the router that terminates the VPN.The VPN clients are split  tunnelled and I have added the public address to t...

HiI got Two questions(1)  In Mutual Redistribution why this command needed  "redistribute ospf 5 match internal external 1 external 2" why not only"redistribute ospf 5 subnets" is enough??(2)  X-----------------------Y       |                        ...

What's the difference between these two T3/E3 network modules (NM-1T3/E3 and NM-1A-T3/E3)? It seems that both modules provide T3/E3 connectivity.Read that the cable is using the 75-ohm BNC connectors for both modules. Is the part code "CAB-ATM-DS3/E3...

I'm having an issue with a "bursty clock" and the HWIC-4T.I'd like to understand if the issue is caused by the Serial Communications Controller (SCC)or is a limitation of the HWIC-4T board design.Does someone know which SCC chip is used, and where I ...

can someone please confirm?119 addresses will be advertized to remote-as 1300 or not?or 119 addresses to 1050 only and 10 addresses to remote-as 1300?how will the config below work?sorry and thanks router bgp 1030no synchronizationbgp log-neighbor-ch...

I just started supporting a small law office and they have an 871 router. I had to factory reset the router b/c no one there knew the passwords and getting into ROMMON was not working correctly. So, anyway here is the basic setup and my question. Fro...

Hi everyone.I have 2 sites (central & remote) with a PBX on each site. Both PBXs are connected via ethernet to the LANs. I have configured dynamic QoS for the IP addresses of the PBXs on each site. The problem is that dynamic bandwidth needs 5 minute...

Hi All,First post on the Cisco forums.... so hi to everyone here, looks like a great community!I would be interested to hear peoples thoughts on a design I am currently working on, essentially we are starting to move a lot of our customers into the d...

hello guys , i wanna know if it is possible to make more than one Site to Site VPN tunnel using the same serial interface and different destinations ...

We have disconntigious non-backbone area.Can we configure virtual-link through backbone area

Dear AllI have a simple set up with a hup GRE/NHRP and a spoke. the spoke has 2 WAN interfaces, f0/0 has a public IP and the GRE tunnel works fine.The spoke f0/1 gets a private IP from a non cisco VDSL router/modem. On that side the GRE tunnel will n...

HiI'm looking for Cisco documentation with best practice guidlines on how to setup a new POP connecting into an existing MPLS network using OSPF and IBGP in the AS.Regards,Werner le Grange

I am looking for suggestions to help me understand why I'm seeing a high rate of fan failures on my routers. I manage 1500 routers, comprising 2821, 2851 & 3845. In the last 7 months, nearly 4% of these routers have exhibited a fan failure and I thin...

Hi Folks,I need a  little help, how do I nat from outside to inside? I need to allow connection to my outside ip address from SIP provider and then pass it to the sip server which has a private/internal.Thank you in advanced I appreciate it.JP