Routing

I have what i think to be a routing question. Below is an what i see to be the problem.The networkMPLS (to remote site)                                       Firewall Cisco ASA 5510 (Between Network and Metro E)172.16.1.1                             ...

Hi!I wonder why I get such a route on my ABR:O*E1 0.0.0.0/0 [110/10067] via 10.47.0.7, 00:05:52, Serial0/0This router is connected to backbone area and area 1. Serial 0/0 is assigned to area 1 nssa only.Also, do I have to have only one exit to the ba...

Ladies & Gentlemen:Can you please review the proposed attached QOS design file, and please provide your comment.  I got two WAN Core Router, dedicated for each Serivce Provider and I also got two dedicated VPN termination router. For braches connecti...

Hello,I'm trying to downgrade an 2811 of 124-15.T13  to 124-15.T7.I can without problem (with TFTP) copy a IOS T7 over the flash and I can see it with sho flash:copy tftp flash:boot system flash c2800nm-ipbase-mz.124-15.T7.bincopy running startuprelo...

HiI have a an EZVPN Server with static IP  address and unfortunately, EZVPN Remote clients(network extension) that  will have dynamic IP addresseses.Everything is working now.EZVPN Server is on Site_AEZVPN Remote Site (Dynamic IP ) is Site_Bshow cryp...

HelloI am looking for help in securing the VPN Box by allowing only VPN Trafficrest all internet traffic should be blocked.here is the configuration, can someone input.###VPN Router###crypto isakmp policy 1 encr 3des hash md5 authentication pre-share...

We are connecting a couple dozen sites together with MPLS services from our provider.  We plan to router through the provider network using BGP.    We're thinking to use the same private BGP AS (e.g. 65001) at each of our sites by using the allowas-i...

Can anyone provide a volatility statement from Cisco for the 2821 routers and a procedure to erase the contents of any non-volatile memory?  I need this before I can return an RMA'd router to Cisco.Thank you.

We currently have a T1 at our DR/Mainframe site for connectivity to WAN with EIGRP. We will be moving to a 6MB DS3 over the WAN with BGP shortly to accommodate our DR plan with existing infrastructure, and the T1 will be removed. We are also moving f...

RT3800 series router HWIC-4T and NM-4T addition to different interfaces? What difference?  please much detail as possible 。  From the function that                           thank you very much!

I am trying to set default next-hop route on vlan10 and vlan20 interfaces because I wanna split up traffic on c3550 to reach two different ISPs. Somehow the route-map could not be applied on vlan interface. If I set just next-hop command then it work...

All:Have a situation where we're running L3 MPLS to one of our remote sites.  I'm in the process of re-organizing the OSPF network such that it aligns a bit better with the design guide/recommendations.Currently there's the core routers (area 0), the...

Hi GuysI try to set up traffic limit on this router but without success. Can anybody write example for my problem. I need different traffic limit for two IP addresses, for first IP 1Mbps and for second IP 3Mbps. Is it possible to do with this router?...

Hi,I want to configure routing between LAN A (192.168.1.0) and LAN B (192.168.4.0)The router model is Linksys RV042I want users on LAN B to connect to internet using 192.168.1.1 gateway, which is an sonicwall firewall (Internet)Pl help..