Routing

What is the reccomended bandwidth allowance for voice signalling?On our WAN routers we generally have  15% of the bandwidth allocated to anything marked with ef which is all the voice data.But what is the best approach for signalling?Should the confi...

HiTelecom provides branch office connectivity to headQuarter using MPLS.Single Router at branch office terminates MPLS link, its also the default-Gateway for users.Routing protocol on LAN is ospf ; Bgp config is provided by telecomI receive tons of t...

Dear Experts,I would like to prioritise multicast & unicast  traffic through my STM 1 ethernet link on my Cisco 3750 Switch. below the is the requirement. could you please help me to configure in a best method way so that i can acheive the same .    ...

Hello, first sorry for my English, is bad. I have a problem with a nat cisco 2611 router with adsl wic, the configuration I think this ok, but not working properly. I put the configuration and the result of the debug ip nat. Thank you.DEBUG IP=======...

We are adding 3 mpls sites that will terminate into a 3750 but cannot rurn EIGRP. This 3750 also terminates other Metro LAN offices as well that run EIGRP.  Am I better off running OSPF and redistributing between EIGRP or running static routes for th...

Hi   How is the best way to send an ip block to a router that is not part of my network,I have      Area 1   <---->   Area 0  <----> Area3,An external router is connected to a router that belog Area3, so I need to send an Ip block to that external ro...

I have an MPLS connection from HQ to 10 branches via BGP.Our DR site is one of the MPLS branch links. DR also has a point to point connection to HQ via BGP.I am curious about some results with prepending a default into MPLS from the HQ site,Under nor...

Buenos diasConsulta  tengo este modelo de equipo Cisco 7606 con el siguiente IOS  c7600s72033-advipservicesk9-mz.122-33.SRB3.binLa pregunta es: este modelo de  equipo es capaz crear VPN (ipsec Site to site y remote access) por  software, ya que no te...

I have a situation where I'm trying to advertise only 4 host routes from a /24 network to my BGP neighbors.As an example,#R1interface g0/0ip addr 1.1.1.2 255.255.255.0standby ip 1.1.1.1router bgp 1network 1.1.1.4 mask 255.255.255.255network 1.1.1.5 m...

Hi,I want to insert the IOS into the cisco 7206VXR Router as it now at the Rommon mode,may i know how to check the how many flash memory available in Rommon mode,so i can download the respective IOS and install it.thks-Gilbert

hi expertI am trying to redistribute default route into eigrp,  router eigrp 1redistribute staticredistribute bgp 65555 metric 1000 100 255 1 1500 route-map get-defaultrouter bgp 65555bgp redistribute-internalip prefix-list def-route swq 5 permit 0.0...

Hi all!I am new to using GNS3, but know I realize that I just have routers and an Ethernet Switch. Is it possible to emulate a Cisco Catalyst IOS somehow? mike