Routing

Hi, A customer has a Cisco 2821 router with two ethernet interfaces and two HWIC interfaces connected to different ISPs.Interface G0/0 has private IP address 10.10.10.10.Interface G0/1 has a public IP address from a pool of IP addresses from ISP-A.Di...

Hello,I have a problem with my ps3, when I do a test network connection, it fails in the test internet connection step, it shows 80710102 dns error.The IP of my router is 192.168.1.1, the IP of my ps3 is 192.168.1.20. I have a laptop with 192.168.1.2...

Helo, everyone i have a problem with my Cat6500 sup2/msfc2/pfc2The approximate topologi is such:PC(ip=10.0.5.254)---dummy switch---Cat6500.Initial Catalyst port(to which pc is connected) in set to L2 access vlan 700, vlan700 SVI have ip unnumbered co...

Cisco IOS QOS Solutions Configuration Guide, Release 12.4 says WFQ is enabled by default on interfaces configured for Multilink PPP.But when I "show interface" on the multilink interface I see:Queueing strategy: fifoOddly, the two T1 serial interface...

I'm facing a issues since couple of months.. I'm running EIGRP in our network and OSPF on MPLS network(connceted to our network), redistributing static routes in both.the problem is that even though i remove some static routes my network is taking th...

After a lot of digging about, I've found out that my ISP has switched me to another ISP network (nice of them to tell me). My username has changed and my once static ip address now needs to be obtained automatically from my ISP. Can someone please re...

Dear All,I just need to confirm that either 1861 CME routers support switchport port-security .... commands are available???If yes then on which IOS and if not then what is the alternate to fix the port security on the 8-port ethernet card?thanks,

Hi,We have a primary WAN network as a MPLS and Backup network as a Spoke to Spoke DMVPN cloud over internet link using two seperate routers.1. Router 1 --> EIGRP AS 1 on the LAN and BGP on WAN at MPLS2. Router 2 --> EIGRP AS 1 on the LAN and EIGRP AS...

Posted this in the VPN section - apologize in advance for cross posting, but I'm kind of in a bind.We've been pushing tons of  replication traffic lately through a VPN, and have been using a route  map to direct that traffic specifically to an OC3 (b...

helloi'm trying to figure out why in the modified eui-64 process the universal/local bit is inverted?Why would that matter?Thanks in advance.

Hello guys,I'm a little new to Cisco tech. So i have this question:I have a 2811 router witch by default has 2 FE ports witch can be configure 1 for WAN (ISP) and 1 for LAN (internal network). My question is this: what module / solution do i have to ...

Hey guys,Im working a project to design an IXP in Bolivia, and need to simulate the network topology, given that the links between IXP and ISP would be supported by BGP4, is there any Cisco software product like packet tracer able to support BGP? or ...

Hi All,i've been struggling a little bit with internal services (as WWW) to be accessible from my external public ip address. I've remved firewall and particular configuration and left "only" nat, i'm interested in let 10.0.102.8: 80 to be accessible...