Hi,Is it a similar command for ISR router; like show asp drop on ASA, to see the dropped packets? I have some asymmetric routing issues and trying to capture the dropped packets.Thanks
Forum Posts
Hi All,We are working on Multidomain routingI want two different ip of same subnet (int fa0/1 -192.168.10.0/24 - CE end) to communicate with two different VRF (cust1 and Cust3), please help me with the configuration Path should be:192.168.10.10 -> 10...
Resolved! Multiple Vlan to switch port
I Have cisco catalyst 2960-S switch with fortinet 30E as a gateway.have default vlan 1 and one new vlan 22I want to add few ports to both the vlan 1 and 22 so that i can connect the wifi access points to that port and access both vlan's via wifi.
I've always been terrible in configuration, so I need some help / tips for my assignment.Based on what I was told, in case if one router is down, I should still be able to ping all PC to the other end devices due to HSRP. So how do I configure as per...
Resolved! Cisco Routers Redundancy
Dear All, we've four Cisco ISR 4331 routers (2 for WAN & 2 for Internet) and two FTD 2130 Firewalls for edge security. we're studying design scenarios for connectivity between those devices. And planning to configure first hop redundancy protocols li...
Hello All,I have a server(centos 7) and I created a VLAN (Vlan 9) for the server, I created an ACL to access the server. I put the ACL in the VLAN server (Vlan 9) with IP access-group **** out, but the server cannot access the internet like ping to g...
Hi all, I think i'm being stupid and missing something obvious so please help to make me realize what i'm doing wrong.I have configured a CBS350 switch stack with 4 switches. I have assigned all of my untagged and tagged VLANS using general ports.I h...
Please Help, I would like to buy a router which support fiber optic connection for my office, about 20 people and connection to more than 60 devices. Please can someone refer a model? We wanted to choose C1112-8PLTEEAWE1 but found out it doesnt suppo...
Hi,I am bit confused with EVPN MAC-IP Synchronisation and re-origination topic, can some one please clarify below queriesIn the below evpn topology PE1, PE2 are All Active mode, Host H1 is multi-homed to PE1, PE2 nodes CE device when hash the AR...
Resolved! Cisco ISR C921-4P
Hello I am looking at the router in the subject line. Upon reviewing a CISCO partner website there were various licenses listed for purchase so I’m trying to figure out which licenses I need for basic functionality out of the box such as just router ...
Hello, Does anyone know the exact meaning of these messages (errors)?: RP/0/RSP0/CPU0:HRDOP18#sh log last 100 | i RP-RED-LOST-NSRNRWed Nov 9 10:13:20.773 CETRP/0/RSP0/CPU0:Nov 9 08:23:25.575 CET: rmf_svr[132]: %PKT_INFRA-FM-3-FAULT_MAJOR : ALARM_MAJ...
Hallo,I have an interface VLAN configured for WLAN users. The VLAN method shows MANUAL but the clients do not get an IP address. This is the only switch whose VLAN is in MANUAL method (the rest are NVRAM and the users of the other switches get an IP ...
Resolved! PBR
If we have PBR command like below : set ip next-hop verify-availability A.A.A.A 1 track 1set ip next-hop verify-availability B.B.B.B 2 track 2set ip next-hop verify-availability C.C.C.C 3 track 3 The traffic will be re-route to B.B.B.B if track 1 dow...
Dear specialist teams,I have an issue about setup branch. Currently we used Cisco ISR 4321 router as main router and provide DPLC as configure below. Does the configures are stable for more branches or what. I am facing unstable connection for the th...
