Routing

helloi am useing cisco 1841 routerall MRTG configuration has been made but i cant see traffic .what should i check ?my config file on PCstart /Dc:\mrtg\bin wperl mrtg --logging=eventlog mrtg.cfgWorkDir: c:\mrtgRunAsDaemon: yes# Created by # cfgmaker ...

Hi Folks,I am facing a very interesting scenario on my routers.I have Routers R1 and R2 connected as mentioned below :R1 -> MPLS SP1 - E-BGP PeeringR2 -> MPLS SP2 - E-BGP PeeringR1 -> R2 - Back to Back Connection for IBGPOn R1 :I am learning a Route ...

Hello everyone.I've been in search of a 8 port managed switch solution that supports PoE and 1Gb connnectivity for some time now. I need to support multimode fiber over long distances (FX-100) in some areas and in most other locations gigabit SX or L...

Hi,I am using 2 2960 switches and 4 1840 routers.I want to know how to achive redundancy on routers and switches for my design.My objective is as follows:I need to run bgp on routersIf linkA fails, traffic flow has to be throgh linkB and linkDIf link...

I have a cisco 1841 router connected to internet,We use NAT for internet access for the LAN behind it.We are trying to reach a Video confenrencing server on the Internet from the LAN behind the 1841 but the test fails.We are unable to telnet on 1719....

Hi,Im planning to deploy GWIP between our headquarter and the remote branch.As you know I'm a Cisco man and I dont have exerience in Juniper, however it would be good for me to learn new technologies.I'm comparing between Cisco 2911 ISR router and Ju...

I have a project to make a second datacenter that is located in a different geographic location a hot standby. Our goal is to make this second datacenter an immediate failover with minimal downtime. I know this can be easily accomplished with traffic...

If suppose in 1 switch (pure layer 2) vlan 2 & vlan 3 configured with 1 pc in respective vlan & both pc's having same mac address wht action will switch take ?Thanks in advance.

This is the scenario:          LAN       Server  (using IIS service)                               [/WebFileAsp] <--------------------> (  Router   ) <--------------> INTERNETprivate IP 10.10.10.2                 public IP 200.1.2.3I want to enter th...

Dear all,Fighting during late 2 days with 2811 router. It doesnt recognize inserted 4ESW HWIC module.IOS version should support this hardware.Please take a look at routers output.*Mar 22 09:51:16: %SYS-5-RELOAD: Reload requested by admin on console. ...

Hi All, I have a scenario given by customer and I am trying to figure out solution for that. See the scenario below                                           Link AServer Network---->Router<------------------->Router---------CustomerA                ...

We have a hosting center and a corporate office that will be connecting to the same ISP.  The ISP gave us a /24 netblock and the hosting center and corp office are connected via metro ethernet.  I would like to use a /25 at each location and have fai...

Not sure what the term is that I'm looking for here, but is it possible to take and combine 2 ISP's into one "connection" each ISP we have different block of IP's assigned and connection types.*What I'm trying to acomplish, I'll try and give as much ...