Routing

hi guys,I am creating access-list to allow 192.168.40.25 to access 10.0.0.0 network and vice versa on port 21, 22 and 23I got ACL applied on the router and 192.168.40.25 (host) can access any device on 10.0.0.0 network successfully, but no one from 1...

Hi experts,When working with OSPF NSSA lab, I was trying to originate a default-route to Area 0 from NSSAR1 ------------- R2-----------------R3 area 1 NSSA AREA 01. In R1 When i use command "(config-router)#default-information originate alway...

I had installed a new SUP module in the router.Now that is in Standbymode and in RPR mode(STANDBY COLD).I could not execute any commands in standby sup module.which is the command to start the utility to work this???Many Thanks in Advance.

Is it possible to get some calculation on the overhead on moving from standard GRE Tunnel to IPSEC GRE Tunnel.With GRE Tunnel when I do a normal ping to another network on remote end it takes 150ms what is expected with IPSEC GRE Tunnel.Any suggestio...

Hello folks - I have a stack of 3750 switches that are trunked to several 2960 switches using MMF (LT/SC connector). The SFP that is in use is GLC-GE-100FX. However, all the trunk ports between the 3750 and the 2960's are running on half duplex. Ther...

Hello,We are running RIP v2 between the Customer Edge Router and PE. PE advertises default information to the CE and CE advertises only two of its connected segments to the PE.We are happening to see a typical issue, where CE not sending its v2 updat...

Greetings,I was wondering if anyone out there can help me with a supposed to be "very simple" Point to Point MLPPP router configuration. Currently we have two of our branches connected using one P2P T1 provided by AT&T, and now we have installed two ...

Hi, Does anyone know of any good sites that would have configuration examples or design suggestions for setting up a Cisco 2851 ISR to connect to an SMC 8014 (Comcast Gateway/Cable Modem)? I am trying to setup an use the 2851 as my core router/gatewa...

How to configure vpls on 12000 series. i can able to create l2 vfi name manual etchow to apply on vlan interface.I didnt see int vlan command to apply xconnect vfi . please help.The same issue on ASR 1004 also

I'm trying to get a remote LAN to see my current LAN. I have a dedicated Point to Point T connected via two Cisco 1721 Routers. I have the ethernet port of my NEAR Cisco router connected to the LAN port of the Multitech router with an IP Address of...

Hi,wE want to upgrade the IOS platform on our router. The IOS version we are running on now is "c2800nm-ipbase-mz.124-3i.bin" (from show version).We want to upgrade to "c2800nm-ipbasek9-mz.124-25a" so as to enable us implement GET-VPN on our network....

Hi all, I have replaced the standby module of 7600 series due to a sup hang-up.Now the added new SUP is stuck in STANDBY COLD.before it was in sso mode and changed in to rpr mode .Also in the bootsync there is two IOS(SRB5 and SRB2) and before ...