Routing

I want to transmit data and voice from site A to site B using 2811. Can you suggest what type of interface card that I need to buy and it's config.tq

I want to turn a Cisco router to be a DHCP server, will it support authetication. I want to restrict the hosts which can get address from the DHCP server.Thanks,

I'm receiving this error on a UBR7111. Anyone know a fix?

I dont exactly understand these concepts. Has anyone a clear diagrammatic defintion with an explanation. eg/ does the multipt f.r always traverse thru a f.r switch...will all m.pt connections go thru difft or the same f.r switch to the sub i/f or i/f...

Does RSVP determine what incremental delay to specify for each router so a total end to end delay is not exceeded? Or as an example, if the RSVP protocol determined there are 5 routers in a path and its end to end (Sender to Receiver) delay requireme...

hey all, I need to give traffic bound to specific URLs priority on the network... www.cisco.com for example. What would be the best way to configure this? I'm running on 7206VXRs. Thanks.

Hi,We are having 1760 Router, we are planning to add BRI interface on this router so that we can use it for Video traffic over BRI.Please let me know : How many ISDN BRI ports can 1760 Router supports? Which interface card we need to purchase?Is it p...

I have a branch site having issues with frame-relay.The branch is configured with FRTS. Traffic is shaped to 64k/64k(cir/mincir) and adapts to BECN. EEK has been configured for the PVC.Lately the site is experiencing intermittent frame-relay flaps ab...

I have applied rate-limit to an interface to limit available bandwidth to 30mb and it is causing issues with FTP. I applied this command:rate-limit input 30000000 15000 15000 conform-action transmit exceed-action dropfor int and out.

I am very very new to this technology so please bear me out with the simple questions. I have a network all ready set up which is SBS 2003 and a 2 nic setup, an ADSL Netgear modem/router/firewall.I now need to have a link to another company in order ...

According the diagram 802.q will make another 4 byte overhead so it will 1522switch also 1500 system mtu so it will forward 1518(frame overhead 18 byte )

Hi,We have a client who is looking at potentially doing 1+Gb Internet traffic - We are considering dedicated hardware for the upstream feed, and back to client hardware.Would like opinions on the most cost affective hardware for this solution.Upstrea...

Why authenticatiion Default and NO_AUTH. I am totally confused, please helpaaa new-modelaaa authentication login default lineaaa authentication login NO_AUTH noneline console 0login authentication NO_AUTH

We are in the design phase for our new VPLS MAN network.We will have about 60 distribution POPs that will be interconnected through a VPLS full-mesh network.As I understand, the provider's VPLS network is like a big switch with a single vlan intercon...

I replaced the router with a 1750 router with ISDN as backup (T1 primary) I forgot to put backup delay command under serial int (as shown below) the isdn kept connecting/disconnecting within seconds and we got like $23k for isdn bill I am wondering i...