Routing

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Webinar

 
Labels

Forum Posts

If you have an existing connection that is manually summarising a network block as 10.90.0.0/18 subnet, is it possible to use one of the subnets within that block for another remote site even though it is being advertised in the summary route or woul...

For the two routers(located in different location), they are learning the same BGP routes, but I'd like to redistribute BGP into the EIGRP so that router B redistributed BGP is always preferred over Router A redistributed BGP routes. Does this metric...

Hello,The single match statement creates “OR” condition. For “AND”, it requires two separate commands. route-map L3andVZB-Down permit 10 match ip address L3-FE-IP match ip address VZ-DS3The above will show up as single line when you do show ...

pkpatel by Level 1
  • 649 Views
  • 4 replies
  • 0 Helpful votes

hiI have two routers, A and B.router A has got a link to service provider X, and receives a full bgp table 274K.Router B has got a link to service provider Y and receives as well a full BGP table.there is an IBGP session between A and B.my question i...

kayih by Level 1
  • 828 Views
  • 4 replies
  • 0 Helpful votes

I have 1 router that has 2 atm cards and both connected to a tester(traffic generator) back to back.I cannot ping the tester, my one side/interface configs are as below:interface ATM1/0 ip address 192.1.1.1 255.255.255.0 load-interval 30 atm clock IN...

have a problem with Cisco As 5850 RAS. It got hang after every 2-3 days and at that time customers found unable to connect with the server. We have to power-reset the RAS to make it working again. In SHOW-LOGGING command it shows the following Errors...

Hi,I want to harden my internet router.Any link on this.I cheked few links and find out that RFC 1918,3380 address to be blocked on externla int.There is one entry likeaccess-list 101 deny ip host 0.0.0.0 any&access-list 101 deny ip host 255.255.255....

sushil by Level 1
  • 1074 Views
  • 6 replies
  • 0 Helpful votes

Hi All,One of our UK office has 2Meg ISP line terminating on Cisco2801 rtr with WIC-1T= installed. The 'Show inter ser 0/12/0' o/p showing it as T1 BW..does that sound correct..?************************Serial0/2/0 is up, line protocol is up Hardware...

fortis123 by Level 1
  • 519 Views
  • 1 replies
  • 0 Helpful votes

Is FRF.15 implemented/supported by Cisco.Also whether the implementation depends on platforms , ie: is it supported on a 2800?If yes ,would be great to provide a url on config/debug details.Or a different terminology is used ?

amms68958 by Level 1
  • 677 Views
  • 2 replies
  • 0 Helpful votes

A couple weeks ago I experimented with multi-area OSPF and was confused by the output of my "show ip ospf database" command. I didn't like the way some of the "Link ID's" were network ID's and some were router ID's.Everyone here was very helpful and...

Is there any software tool available toanalyze traffic flowing on wan link ?Also badwidth utilized by application ?and will the result be real time ?please help regards pushpak