Routing

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Labels

Forum Posts

A couple weeks ago I experimented with multi-area OSPF and was confused by the output of my "show ip ospf database" command. I didn't like the way some of the "Link ID's" were network ID's and some were router ID's.Everyone here was very helpful and...

Is there any software tool available toanalyze traffic flowing on wan link ?Also badwidth utilized by application ?and will the result be real time ?please help regards pushpak

I am using two supervisor engine in 7613 router but onr in slot 7 and another in slot 8 but the problem is one supervisor engine is not working , it is showing orange LED and when i am applying "sh module" it showing 0000 value in MAC and unknown in ...

I added some access lists to my core switch which resolved some access issues. However I don't see any counts against that ACL ... what are the rules regarding when you see hit counts against ACL's ??ThanksBrent

I'm trying to inject external eigrp routes into my providers MPLS/BGP network. I only see the route (in the bgp table) on the router where the redistribution takes place. It's not being populated to the neighboring peers through the MPLS/BGP. Since ...

Running IOS 12.2(18)SXD6 on a 6509Have gigabit ethernet modules 6148, and trying to trunk a port. There is no option to set encapsulation for dot1q. Apparently this is the scenario when only ISL is supported by the module. Is there a workaround/ve...

jovaughan by Level 1
  • 1121 Views
  • 4 replies
  • 0 Helpful votes

Hi,Can anybody help me to know how may channel / Timeslot I can configure in Channelised STM-1 Card installed in 7613 Router.Is there any restriction?R.B.Kumar

Hello Folks, we have a problem when i try to set a dialer connection in a Cisco 2800, series.When i set the type of encapsulation in the interface bri it appears this message:"Encapsulation not allowed on voice only interface", what does it mean?, i ...

Sitov1982 by Level 1
  • 936 Views
  • 2 replies
  • 0 Helpful votes

All,We have 3 buildings that are side by side. We have a fiber run between two buildings for a switch to switch connection (bridged), and we have a P2P T1 to the other location on a routed network. Ok, so we are going to try to phase out the T1 at th...

I have run PRB on multiple Cisco router 2800, 3800, 6500 etc. We use it for redircting to a WAN Accelerator. We setup the ASR the same as all our other with a route-map and an match criteria of an ACL and added the "ip policy route-map" statement to ...

tfbissett by Level 1
  • 737 Views
  • 2 replies
  • 0 Helpful votes

Dear Freinds, I need to configure Channelised STM on Cisco 7613 Router (7600-SIP-200) 1 Port with respect to E1. Requesting to please guide me or share config.Regards