Routing

We have dual-homed BGP, with AT&T and Sprint, with links from ISP terminating on differentchassis.We also have different network blocks from each ISP, let's say block A, B, & C from ATTand block X, Y, & Z from Sprint. What we like to do, is if traff...

hi guys from cisco experts. i would like to show to you a sample network diagram of an existing network and proposed network with the involved of 2 ISPs and WAN router.i am attaching an image just below if you wish to see it and to be able to underst...

I wish to set up our Routers with username ... secret 5 ... (encrypted-secret). Can you recommend any tools for generating an MD5 encrypted secret for cisco ios. Thanks in advance.

Hi i am facing problem on intervlan routing.i have 2 vlan for depart marketing vlan 10 & account vlan 20.On router i have define 2 sub interfaces F0/0.1 with encapsulation dotq1 ip add 192.168.1.254/24 (market...)F0/0.2 with encapsulation dotq1 ip a...

Hi All, I have two routers mulithomed to one ISP so we have 2 CE's(r1 and r2) with ebgp peerings with 2 x ISP PE routers.Our own two routers r1 and r2 have an ibgp peering.My question is as follows. Recently we had issues on the primary due to insuff...

Hi guys,Need to do this without rebooting the device. How do i do this?Thanks.

24w3d: gateway address is one of our addresses.24w3d: ICMP: bogus redirect from 10.105.28.26 - for 10.105.28.2 use gw 10.105.28.25i received an error message like above, when i turned on debug ip icmp and tried to ping 10.105.28.2 which i confi...

Hi,We are using cisco 3845 Router and have two redundant links. Interface Serial 2/0 has the first priority to send data . I have blocked “Host A” on Serial 2/0 , But other one interface (Serial 2/1) is opened for the particular host. But the ...

Hi We have 2800 router with IOS 12.4(23) and in that when i try to add reaction configuration for more than one metrics ie for rtt,jitter,latency and mosit is not allowing to add more than one here i can configure first and for the second it gives er...

Hi,We are using SPA-1XCHSTM1/OC3 card for our STM1 Point to Point link. We have done the configuration in the following method to club 3*T3 in to single multilink.• Framing type is set to SDH & Aug-mapping set to au-4• Under Au-4 1 tug-3 1, 2 & 3...

can I use my router as tacacs server? If yes, how to configure? If no, what other local authentication on the router I can use for multiple users with different level of permission? thanks!

[withdrawn for re-editing]

I have a 2800 and on the interface to the provider, there are increasing amounts of unknown protocol drops and I am hearing that the router is down and people are getting dropped.