Routing

Hi ,I am trying to multi-link 3X T1, T1 are errors free , both going from point A to Z..one T1 is 127 ms latency , number 2 T1 is 60 ms, number 3 T1 is 114 ms .T1 # 1 going trough 2 hopesT1 # 2 going trough 4 hopesT1 # 3 going trough 3 hopesis it ok ...

I have seen this strange error, ISIS flapped and was back up, but the best forwarding path was unable to forward packets it seems, router not reachable via telnet/ssh , can ping the interface, but traffic was being black holed. BGP , LDP session went...

Hii,We are having 2 STM-1 in 7613 Router,In One STM-1 we are having one ISP Link and second STM-1 We are having 2 ISP which is comming from E1 To STM-1 Converter. So now Problem is when We are Doing Multilink with Second STM-1 (with 2 Diff ISP) Multi...

Hi,we are WS-X6582-2PA Enhanced FlexWAN Module in 7613 Router..can we put 2 PA-MC-STM-1SM1 (card) in single WS-X6582-2PA Enhanced FlexWAN Module ???

Our network is setup as such:ROUTER A------> 4MbpsROUTER B------> 4MbpsWe are currently running BGP between the routers. both these routers are connected to l3 switches and are in same lan.Please find the attached network diagram.now my requirement i...

Hi,I am trying to configure RIP V2 between 2 Routers. It is working fine.But in debug message iam getting the error " RIP: ignored v2 packet from 192.168.2.1 (sourced from one of our address)"The Router configuration is below:interface eth 1/0ip add ...

We currently have a core site COL and a Disaster Recovery Site called OP. We are currently running eBGP with 2 ISPs from our Core COL site. I am looking for suggestions to extend this to the DR site in case we loose our Core COL site connection or ge...

Hi guys,i have a cisco 1811 router (spoke) with 2 DSL connecions from my provider he is using DMVPN to connect to a 2811 (Hub). My question is how could i share (load balacing) my traffic using both DSL connections ?

Hi Everybody,I'm trying to do some testing with IP SLA and Enhanced Object Tracking and came up with a problem with the commands. I am using a 12.4(15)T7. From the track commands, I want to test the reachability of a host using "track 1 rtr 1 reachab...

Hi,We are multi-homed with two ISP's and are load balancing with OER. We have a WAN connection to our European Data Centre where there is a third internet connection. I want to add this third connection as an OER exit link.As this WAN Connection is...

I'm starting to get confused with this now. Can anyone who's familiar with X25 advice plsOnce a Virtual Channel (VC) is up, can i safely assume that i can have a maximum of 256 sessions per VC?

I have followed the instructions from the Cisco web site but I have not successfully deleted the VLAN.dat. Per the instructions after you perform the wr erase and reload, from privilage mode enter erase cat_4000:flash

I have set up NAT on the border router, so the outside network can remote desktop to a computer in the inside network.This is working fine. Configuration as below:interface fa0 ip nat insideinterface fa1 ip nat outsideip nat inside source static tcp...

hey all, we're working with a customer with a replicated network at two separate data centers. they'll be advertising the same prefix block from both locations (anycast bgp). i've seen documentation where iBGP is required between both data center sit...