Routing

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Webinar

 
Labels

Forum Posts

Hi all,I'm not sure if my problem is because of a race-condition or not.I have a head-office that can access a data center via metro ethernet or a MPLS circuit. For all network traffic to from the head-office, the metro ethernet is preferred. If the...

msrohman by Level 1
  • 3408 Views
  • 8 replies
  • 0 Helpful votes

Resolved! QoS 3750ME

Is there any chance I can configure QoS on fastethernet port to reserve bandwith for specific networks?I tried this configuration:Policy Map pm-voice Class cl-voice bandwidth 30 (kbps) However, I can not assign this policy map to fastethernet...

Hello Net-ProI have a couples of questions?1)in EIGRP if questions says Limit EIGRP on attached interfaces.Is that means we haveto use and Configure neighbor command instead of Network Keyword??2)manual add of mac-address entry shoud Be on the main ...

alsayed by Level 1
  • 395 Views
  • 2 replies
  • 0 Helpful votes

a tech @ teh remote location installed 2x VWIC-2MFT-T1-on 3745..and other 2 on the second 3745.. I am not able to detect those new devices , I can see the other t3 module as well as fastethernet port.. cisco tech said that this is ios compatibilty i...

Resolved! Console question

Alright ... please don't make fun of me. My laptop only has usb, rj45, and rj11 ports on it. Is there any way to console into a switch/router with it? Is there any adapter I can get to make this work?

Dear Friends,I need some help. We have two switch 6509E with Flex-WAN module. I want to configure the switch to use the Flex-WAN module to do the connectivity towards the WAN on redundant mode. Can any one help me by providing some doucment or link d...

I cannot configure MPLS on a 1700 router. Version 12.4!!I type in IP CEF then go under each interface either s0/0 or e0/0 typetype in MPLS IP it says command unrecognized. What am I doing wrong ? I can't configure it from both Priveledged or global m...

- When Cisco says that its IOS supports many different WAN protocols in disparate systems, what does this mean exactly? Do the WANs talk to each other at the Data Link Layer of the OSI model? Do they participate at the Network Access Layer of the T...

What is the differnce between "shape average" & "shape peak" in QOS shaping ??does it use the same concepts of burst conform & burst exceed as in policing .Kindly explain with a example !!!

One of my clients is running a 1800 router with ios 12.2. The client had dual adsl and wished to use one as the primary and the other as a fallback/reduntant line. is this possible and how would i go about this.

Jembeck22 by Level 1
  • 419 Views
  • 3 replies
  • 0 Helpful votes

Hello,I have a 2801 with HWIC-4ESW and three isp connection with tracking, sla etc. (read config)ISP1 and ISP2 links works fine, but ISP3 every 1-2 min cannot ping gateway and track state go "DOWN" state. After that i try ping gateway from vlan3:#pin...

Hi folks,I'm trying to secure a router by using "ip inspect". The router takes all the commands but from a PC behind the router I cannot access the Internet. However if I remove the access list inbound on the external interface it works fine. I was u...

d.hodgson by Level 1
  • 429 Views
  • 4 replies
  • 0 Helpful votes