Routing

I have a 2620 here with WIC-1DSU-T1 and WIC-1ADSL connected to the same ISP. T1 and DSL interfaces are on the same WAN e.g. public IPs X.Y.Z.10 (T1) and X.Y.Z.20 (DSL). Gateway is X.Y.Z.1 for both (T1&DSL), net is /24. What is the proper config for t...

Our router keeps flapping with it's OSPF neighbor. I think it may be due to the CEF process. Doesn't this look high to you? Looks like this for about 30 seconds of every minute.DTR01AHVLNC#show proc cpu | ex 0.0CPU utilization for five seconds: 7...

There are 3 LAN sites that I would like to connect to a WAN, The sites are all in the same state but are spread out over a large distance. Each LAN has approximatley 100 users, Verizon is offering a fractional T1 line via a frame relay conncetion? Sh...

I was asked this morning if this was possible and it's really beyond my knowledge base so I thought I would begin by asking here for some insight.We have a 50mb fiber circuit delivered to us from Optimum. Terminates in there router, then delivered to...

We have a gig link from Verizon. two sides are 15 miles away. Today, one side shows up/up the other down/down. Why is that? what kind of connection is this?Thanks,Han

guys which one of the ipv6 address is right or whats the difference between the followingFECO:0:0:E::1/64FECO:0:0:E:1::/64

Hi all,Do the router-id in OSPF has anything to do with routing decision..? Or its just an identifier..? I have an ASA enabled for OSPF and 10.100.25.x n/w is advertised via ospf (which is ofcourse we needed) but the ID advertising as 192.168.1.1 (ma...

If I have a serial interface configured per below, is the hold-queue doing anything?My understanding is hold-queue is a fifo function and by applying the QoS policy aren't I using CBWFQ in the interface?policy-map P-QoS class VOICE priority 256 set...

Hi,Trying to work out the best method for a small problem we have.There is a single 2800 series router with 2 ethernet interfaces, each one goes to a 6500 series switch.The router has a bunch of isdn's attached for our FOIP environment.What we want i...

Hi all,s simple question : is it possible to have SNA over IP/PPP. Actually, we have to migrate a network in which we have SNA over X25 to a new netwok IP/PPP but we still need to have to transport SNA. So is it possible to do it over IP/PPPThansk in...

just a quick one do we have to config port priority or cost on both side of link.....for example swicth A is conected to swicth B....IF WE WANT THAT A BLOCK PORT SHD BE IN FORWARDING STAE DO WE HAVE TO CONFIG PRIORITY OR COST ON BOTH SIDE ON INTERFAC...

Hello Everyone..Simple question.."Is there a command that can tell me how many times the node (Router) has chosen a specific route?"Example:If I wanted to know how many times the default route has been used...Let me know..Mav

Hi.A site is connected to internet through 2 different ISP.The traffic flows from the LAN to internet across an ASA forwarding then the traffic to router 1. I wish now the traffic from network A to be forwarded to router 1 and traffic from network B ...