Routing

Hi All, I relatively new to ASA5505 devices, but I try to understand the following: My ISP provides me with 4 static IP's in a so call routed subnet, so no NAT is available. I don't understand how to setup a internet connection for the inside network...

Does Cisco router IOS support the DHCPv6 configuration on it? as Deploying IPv6 book is mentioning that Cisco router can not act as a DHCPv6 server!!!regardsDevang Patel

We have incident that a route has been deleted on one of our router. The next hop was changed. On this situation how can "sho log" helps for the investigation? Is there any other way of tracing and knowing what happens? Thanks

Hi;i have Cisco switch network and am having an issue. Due to no visible reason a few of my switches stop responding to ping/telnet/cdp etc but they still pass layer 2 and I can ping devices beyond the affected switch/switches. Its happening only on ...

I currently have 2 ds3 circuits. One circuit was provisioned by RCN and the other is from Verizon. The circuits connect our office to our datacenter and trunk the necessary VLANs on all trunks ports the circuits where the circuits are connected. STP ...

Hi,I am having a problem with an ISDN back up link between a cisco 1841 (1841 Software (C1841-ADVIPSERVICESK9-M), Version 12.4(10)) and a cisco 3745 ((C3745-ADVIPSERVICESK9-M), Version 12.4(12)).The description of the issue is that when the main link...

Dear all,Can anyone advise why the ping response is such a different for seg-loopback & end-loopback ping? SING#p atm sw 1.1922 0 1922 endType escape sequence to abort.Sending 5, 53-byte end-to-end OAM echoes, timeout is 2 seconds:!!!!!Success rate i...

hi,what's the difference between the two methods of softly resetting BGP sessions? I mean between :"clear ip bgp xxxx soft in"and Route Refresh? How do I configure Route Refresh by the way?

guys if two routers are connected and i want that first router shd not recontract rip routing table or interface flapping .....what would be the easiest way to do that.....thanks

Can someone point be to documentation which explains whether the 3845 NM-T3 module is hot-swappable?

Sir, I'm trying to communicate between two routers:-1) In router 1, rip routing protocol is running with multilink and VPN tunnel in old setup.This router is connected with leased line with routers of different location.2) In router 2, Ospf is run...