Routing

Hello All!I have VPN aplication a that need access from outside to inside by IP (not tcp or udp) protocol 250.Another words all trafic that have been received on outside interface protocol 250 need be forwarded to inside workstation.If I use static o...

hi,i have 3845 router having E1 link with me SP.i use this E1 link for my internet traffic and intranet traffic,some times the traffic destined to internet gets stuck but my intranet traffic shows no problem. after rebooting the router it comes to no...

Can 7206 VXR NPE G2 IOS 12.4 support LACP port channel? If can, how to configure it ?

HiI have the problem with interconnection of the router cisco 2800 with the Fleet 77(inmarsat)by BRI port.The router display error messages that I can not understand.debug isdn error command returns the following error message:*Jan 1 01:10:15.527: ...

I have ONE serial cable which I want to connect to TWO 7600 routers running GLBP for redundancy and load balancing. Will this thing work with a Cisco HWIC in a Cisco Router? See attached document.

Hello everyone,I've got a scenario where we purchased two Cisco 2851 routers and from reading the information below, it says that we will get sub-rate speeds and the Cisco 2800 series routers are not recommended for DS3. We've already bought the rout...

I have been trying to setup logging via tcp on syslog-ng. all the messages come in fine via udp, but when i configure a tcp source, assign it to the syslog-ng target, etc, then configure the router, i don't get any events. i can see the packets com...

Hi everyone,It seems that pppoe termination is not supported on UBR10012 from 12.2.(11)BC3.I can not find any information if this feature is supported in any later ios version.Is there any workaround for termination of PPPoE?Thanks

Hi , I'm in the need of setting up a configuration with a router which would route packets to two different ISP connections based on protocols,failing to the other active connection should one of the two fail.Can anyone give me help on finding exampl...

Hi:I'm using the Cisco hierarquical model to design my network but it is not clear for me which level should I set my WAN connections to different sites (not datacenters or mainsites). Could you give me some recomendations?TIA.

A customer who has acquired a 877 router now wishes to use it at a managed offices location that presents an Ethernet rather than ADSL connection. Is it at all feasible to configure the 877 in this way?

Hi all,Is it possible to use two of cellular interface as primary?Primary and backup use is not possible as far as I searched in Cisco.com.I don't have two HWIC so can't confirm.Cisco 3G WWAN HWIC Q&A TechnicalFeatures and FunctionsCan I configure th...

I recently completed CCNA version 3.1 (cisco academy program) at a local college and the corresponding exam for this is 640-801 if I'm right, however that exam is retired. The new CCNA exam is 640-802 and that includes VOIP, wireless, IPV6, etc. that...

I have an edge router with a few serial, ISDN and a T1 hanging off of it. I want to put a second router online and enable MHSRP or GLBP. I can't seem to see how I could bring a second router online unless I deploy an inline switch but that would leav...