Routing

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Webinar

 
Labels

Forum Posts

As an ISP I have 5 BGP sessions, one of my main AS paths is having major issues on a reg basis so I want to change the load to be "stronger" on another path. Is this just a matter of going from below ....route-map ATT_Test permit 5 match as-path 17 ...

cozyk1515 by Level 1
  • 1506 Views
  • 10 replies
  • 0 Helpful votes

I'm attempting to troubleshoot a problem from one of our frame-relay links back to an ATM DS3 at our data center. Does anyone know if there's a way that a Catalyst 7200 can track incoming packets that have been marked with a FECN or DE flag set? I ...

jnaglich by Level 1
  • 397 Views
  • 1 replies
  • 0 Helpful votes

Hi,We have two core routers at our headquarters, and many of our remote sites have a link going to each router. I've noticed the CEF load-balancing isn't working very well. When I check the routing tables on both routers, I see they are inconsisten...

rstevek by Level 1
  • 383 Views
  • 2 replies
  • 0 Helpful votes

Hello All:Rather new to routing and am a little fuzzy on how to setup PBR. My scenarioI have an existing 3660 Router with a single T1 terminating in it. The attached 3x internal subnet by default will route out that T with the folowing route stateme...

js358 by Level 1
  • 527 Views
  • 1 replies
  • 0 Helpful votes

Hi everybody my partner made a mistake changing the config register in romom mode, He put romm1\ confreg 0x2120 then he restarted the router, but only appears signlike ëëëëëëëëë+++++ë.I tried to restart factory defaults whit the reset botto...

Resolved! OSPF E1 route

Can I know what the does the following statement means?For OSPF E1 router, it is external to the autonomous system. E1 includes the internal cost to the ASBR added to theexternal cost.Does it mean that the cost to reach a other AS is the internal cos...

SpecificationsPorts: min 2 x 1000 BaseT Ethernet + 1 x 1000BaseLX port and minimum 6 extension slotsProtocols supported : HSRP or VRRPSupport Ethernet, fast Ethernet (100FX, 100TX), gigabit Ethernet, Synchron serial , E1, E3, STM1, channelised E1; AT...

I have a 3meg multilink connection going directly to the internet to a service providers network, then a Frame T1 that is coming back into my private network (this private network does have access to internet via different service provider). We want...

Dear sir,We have cisco 1841 router and we terminated 512 kbps v.35 leased line is working fine .and router output is connected to switch and we have 1MB broadband and that RJ-45 also terminated on switch and we r planing to this broadband ip also pla...

Hello;I've got two location with connected 20 mbit site-to-site metroeth.Also there is a backup line g.shdsl 2 mbit.Could i end the both connection on the same device ?Also when the metro line go down,can g.shdsl become online automatically?Thanks.

Review Cisco Networking for a $25 gift card