Routing

Hello all,Would like to know whther the below setup works ??Primary connection :Site C connected to Site B ( point-point)Site B connected to Site A ( point-point)Secondary connection:Site C connected to Site B (ISDN)Site B connected to Site A (ISDN)N...

objective;copy active devices config thru TFTP from a remote PCscenario;pc----6500lanA--sdh ring 1.....6500lanG6500lanJ----sdh ring 2---6500lanZ- lanA 192.168.1.x on vrf- lanZ 10.10.10.x not on vrf- there are core switches on each of the major locati...

Hi all,1. If the local router receive full routing from ebgp peer. How can I filier it to receive only one default route instead.2. Suppose my bgp router connect two ISPs. How can I config local router to avoid to become Transit area.Any document men...

Hi AllGetting intermittent failures using a 1760 router with 2 adsl wics.Looks to me line like one of the lines has a noise problem? Perhaps someone could confirm this for me?sh dsl int atm 0/0ATM0/0Alcatel 20150 chipset information AT...

Hello,I have a private network on 10.0.5.0, with a Websense server on 10.0.5.20. All client machines on the lan use 10.0.5.20 as the default gateway and dns server. The websense server also has another network card with address 192.168.0.2, and the...

Hi,I setup the remote office. It is cisco 871. How do I config the VPN between remote office and central site? any VPN sample config for cisco 871? Thanksrdgs

I need to create a VRF on a Bastion router for management..can someone direct on how I should proceed? I have a physical connection to the Bastion switch and I am not sure how I should proceed with a VRF to only allow the management vlan to be seen.....

My perimeter router is connected with my branch over a leased circuit and remote branch network appears in routing table as OE2, my floating static route on perimeter is installed and pointing towards ISDN interface with the AD of 200 and redistribut...

Clocking with multiple connections.I need some help on figuring out how I should setup clocking in the below scenario. In back of this router is UCM Business Edition.Customer has 2851 with four vwic-mft-t1's (only three in use) and one NM-1CE1T1-P...

Hi,I recently bought a 2811 router ,I have just installed a 1FE HHWIC CARD,but when i power on the router ,it is not getting detected ,is there any setup for installing it or wheather the part No. is incorrect,please give me the correct part no.

HiI am new in Cisco Engineering.I just wounder why cant i use SDM with Cisco 2611. I am using following IOS version.ROM: System Bootstrap, Version 11.3(2)XA4, RELEASE SOFTWARE (fc1)ROM: C2600 Software (C2600-IK9O3S3-M), Version 12.3(18), RELEASE SOFT...

I'm in the process of creating a plan to bond a T1 line to our current T1 line (moving from 1.5 to 3.0 Mbps). Are there any special configuration issues on a Point to Point T1 circuit when used for both Voice and Data if no current QoS policy is in ...

Hi all. I am currently facing sql replication issues between 2 of my sites. I get the error "general network error. check your network documentation" in my server log. I would like to know if anyone face such a problem and what you would do to find t...

can any body explain why we give route maps configuration