Routing

Hi Please see the post "Basic Routing Problem" in this forum here is the link http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Network%20Infrastructure&topic=WAN%2C%20Routing%20and%20Switching&topicID=.ee71a06&fromOutline=&CommCmd=MB%...

Dear Sir,We have Vsat Connectivity to all the remote locations .we have a hub Spoke Architecture .The users at remot e site are facing problem to access SAp appliations .We have tried with juniper WXc ,Can WAAS help me to acelerate the traffic .Tha...

Hi I've been trying to find the next compatible Network Module to replace the NM-16A/S installed on our 3845 series router. THe above module do data transmition rate of up to 128Kbps on syn/async links according to the Cisco site. What would be the n...

I have a simple applet that I am using to monitor the status of the a serial link...if the link goes down the applet brings up another interface that allows for a vpn connection...I am trying to setup some timer that will only bring up the interface ...

Please advice!!!!!I have two VLAN's in the switch. Vlan 1: 10.10.10.0/24; Vlan 2: 20.20.20.0/24. The proxy server in Vlan1, which is 10.10.10.10I would like to do:1- VLAN2 running DHCP in the switch. VLAN2 should be access to the DHCP server.2- VLAN2...

Hello,I got an 1841 router and installed a VWIC2-1MFT-T1/E1 card for our incoming PRI. I got the card setup for a T1 but when I try to do the pri-group config I get the following error:%Please configure network-clock-participate wic 0 first%Insuffic...

Hi we have a situation in which we need to be able to terminiate or bundle 8 T1 circuits on a 3845 router. What would be some recommendations? ie what type of cards would be needed, would those cards need to be have built in DSU's?? Any information w...

I have routers that are setup using point to point T1's and static routing. I am coming from a remote location with ip address of 10.101.x.x The DHCP server and other resources are on the 10.150.x.x and the 10.1.x.x networks. The interfaces for the T...

Hi All,I have cisco 2821 connected with an MPLS link which supports two networks (Network A (Data), Network B (Data & Voice))We a new MPLS link willing to terminate on the same router 2821 which will support Network B (Data & Voice)Condition: Network...

We have 7200 VXR NPG1 router, in which two STM links is been terminated, all of a sudden, STM links went down, when coordinated with provider, they have initiated a bi-directional loop, in which we were not able to see the loop at our end for both th...

What cmd would I use to priortize data based on filename? For example, I have one file called HIGH.txt (30mb) and a second file called LOW.txt (30mb). Using NBAR, prority should be given to HIGH.txt before LOW.txt. Below is my command:rotuer(config-c...

We have a branch office connected by a point-to-point T-1. The branch office router will accumulate CRC and Frame errors and various times during the day. It is at this time that users report issues from the site. I have had the SP test and of course...

Have a 3660, that when following the password recovery procedure http://www.cisco.com/en/US/products/hw/routers/ps274/products_password_recovery09186a0080094774.shtml doesn't allow to perform foward of step 10 on the procedure and doesen't allow to r...