Pls help me id why this link is not coming up at all between our two offices. I have attached here the configs of both sites. It's displaying up,up with spoofing in brackets on both ends? What does this mean? I have no clue in ISDN.
Can a 3640 do MLPPP across multiple NMs? My customer wants to up his Internet from 3, to 6MB. I need to know if the 3640 will allow MLPPP accross 2 NM slots. Thanks.
Thanks for the help with this, its new territory for me. We have two bonded T1's from one ISP currently. We would like to add two more T1's from another ISP for load balancing and for failover purposes.Can I use two of the Two Port T1 WICS in a 281...
Dear allI have seven hub with several routers at remotes.now each router at remote has it hub router. but i to establish other tunnel to other hub but with priority issue for redundancy.any document or sample?regards to all
is there a comand in a cisco 2501 that will tell me if im running 2 or 1 chip or flash?? when i isue the command sh ver... it says that i have 8192K bytes, but with out openig the unit is there a way to know if there are 2 4mb or a single 8mb?? thank...
Hi,I have a system which uses synchronous modems via a leased line for inter-site connectivity, I need to replace the leased line with a dial up link (no ADSL or ISDN available), but I can not remove one of the modems due to it being integrated into ...
Hello,On router interface I receive IP packets with spoofed IP addresses. Is there a way, besides network sniffing, to see on the router source MAC address of that packet?
We are currently running a PIX 515E behind a 2851 router balancing two internet pipes via BGP.It has been recommended to us that we upgrade the PIX to the ASA line. Is there a good reason not to use the Firewall/VPN capabilities available in the 2851...
Dear All, I have two ISP's link for using internet so if primary ISP link fails then secondary ISP will be used as the back up for internet. I have to achieve this thing without using BGP, currently I am using PAT on primary ISP link but whe...
Hi,I have ethernet handoff link between two 2811 routers. following is the topology.<2811>---E1-----<2811>These 2811s are equiped with Nm16 switch card.Trunk is configured on ethernet interfaces. There are 2 VLANs: VLAN1 and VLAN 110. VLN1 is managem...
We are doing router refreshment project. We are replacing 1700 router with 1841 router. But the 1700 router having Ethernet port 1841 router having Fastethernrt port. We are facing some problem while replacing 1841 router. Fast Ethernet port having C...
Hi,We are having MPLS WAN network cloud. Our all offices connects to service provider MPLS cloud. We need to have WASS device install / or operate between our two offices where we have huge data transfer going on contnously . We dont want to inves...
If I change the bandwidth statement on an interface (serial subinterface), do I have to bounce the interface/subinterface for eigrp to start using the new value for route calculations? Thanks
How do I go about deleting trustpoints from my ssl accelerator?no cry ca trustpoint <tpointname> is how I think it needs to be done.Just as a quick question...If I do this - it will not delete any other trustpoints, right? I have about 100 of them a...
Hello.Can someone help me.I have two providers connected to my one router. I have AS with one public adress space - C class.How i can loadbalance incomming traffic betwwen this two providers.Can i split my c class on to two adress spaces with /25 mas...
