Routing

Hi I don't know if this is possible but what i want to do is this:i have an 837 adsl router with 2 public static ip addresses on the dialer interface, I have outbound mail coming from 2 seperate ip addresses on the internal network, i Want to have ma...

Hi all,We are trying to connect some remote offices through an 1811, the idea is to have an Ethernet WAN and an ISDN backup, we already installed the routers and most of them are working well, but some of them are having problems to make the connecti...

I signed up as a client and I am trying to download the 12.4 ios but it is telling me that I got no right to do that . What shall I do do ?Thanks

Is there any way to access a 2811 router remotley to copy an existing config, or boot to a flash card with an existing config?For example if a branch router fails, can you have someone rack the new router and boot to a flash card with an existing con...

HI all,I have a remote router (R1) with 2 neighbors routers (R2 & R3) using EIGRP. EIGRP chooses R2 as its default route.My questions is, what would be the effect in the default route if i used the "distribute-list" command in R1 due to a bouncing li...

Folks, what is the right design approach for this:Imagine I will deploy 3750-48P switches across a building. Total of 1,300 nodes.What's the best way to calculate the number of switches required:If I do 1,300 nodes / 48 ports = 28 switches. Then you ...

Hi, I have a little difficult, i have 1 2811 with that receive an E1 from one ISP and another E1 from one ISP i want to route by one email services and for another only ftp, www,etc.somebody can suggest a config,

I am currently thinking about using load balancing on two EIGRP enabled links. I don't want to use per packet LB.The problem I have is that I would like to double my throughput for FTP traffic to a specific destination. So I want to use per packet ...

Hi, I have a few VPN's connected to my Cisco Concentrator and ASA. The thing is I have never set the life time on the tunnel on the regional sites configs (877's, 1841's), althought on the ASA and Concentrator I have.What problem's would this create...

Hi,I am using a internet router and it is patted to private IP as 192.168.0.1/24.Now on my L3 3560 switch I created some 10 Vlans.like 192.168.1.1/24,192.168.2.1/24 and so on......I don't want vlans to communicate with each other but just allow all t...

I attach the output of the show_run command of my router that is connected to my ISP. The access to internet is very slow I would like to have the opinion of any of you guys who have more experience and are expert on that subject.Can you suggest to m...

We have offices on a managed MPLS network. Two of the sites have there own Internet connection. One of the sites has a T1 MPLS and T1 Internet connection. The challenge is that on one site, some hosts download 10+Mb files from HQ through the MPLS n...