Routing

I am trying to setup 2 routers Lab.Routers: 2501 and 2524.Q. How do I connect these two routers by cables. I have one transcevier only. one rollover R45 cable. I have configure both the routers. But don't know how to connect these and make CN...

We have a 3725 router, two ISP's, one is wired and one is wireless. We also have an ASA5520 firewall in place inside the router. We would like to have failover and also traffic balancing. For example, inbound traffic to our company we want that tr...

Hi,Does any impact when man runs alot of Windows Vista where Ipv6 enable in a ipv4 network. Is there any problem for the network.

we currently have 2 asa's 5505 and a 5510 each connected to a isp which connect inside to a single 3640 we have the default route set to go out one isp and vpn traffic to go out the other. we have some route map polies in place for specific machines ...

Hello,I am trying to get NAT to work on a 7613 w/sup720 and am having some unexpected results.IOS Version 12.2(18)SXF7MSFC3 Sup720Here is the config:interface GigabitEthernet9/44 ip address X.X.100.1 255.255.255.0 ip nat outside spanning-tree portfas...

I have a 6509 with a 30Mb internet connection. During certain times of the day, this connection is maxed out. At these times I am seeing dropped connections from applications including Citrix connections. What are the possible reasons for these dropp...

I'm very new to cisco - im trying to learn but i'm stuckHow do I figure out what equipment I need for a task? Who am I supposed to ask?I'm trying to design a network with 50 users in a Head Office (ability to work from home) and 13+ small branch offi...

I received a new class C from my provider I will be using for BGP. Should I create a subinterface for it or use a secondary IP on the same interface??

I configured NAT on a Catalyst 6500 Switch. I created a Vlan, defined it as NAT Inside and associated a few Switchports to it. I configured a Physical Port as a Routed Port and defined it as NAT Outside. I created an Access-list matching a Class A Pr...

Hi all,I have one issue with my 2621XM router.When a tried to insert "interface mfr" command, router just reloded and repported following error message:System returned to ROM by error - a SegV exception, PC 0x80468584Cisco saysERROR: This router was ...

Hi,I have a very old 2621 that i use for lab testing. I need to upgrade its memory (DRAM and Flash), but can't find its appropriate DataSheet (i can only find 2621XM).Any ideas on the whereabouts of the datasheet?The router now has 64M DRAM and 8M fl...

In the commandx25 route nri1 xot ip1 ip2It tries the XOT connection to ip1 for 30 seconds and fails and then tries to ip2. How can I do to change the 30 seconds period?.

Can I ask what is the max speed that the sfp ports on the 3560G switch will operate at. Is it 1Gb ? . I am currently trying to decide whether to loacte some of my switches on particular floors of the building and connect them via F/O cable back to th...

Hi everyone,First of all, I may misunderstanding about RNR (Receive Not Ready) function, substantially there might not be concept of sending interval for RNR though, I posted it to clear my question.HOST ---- STUN/SDLC ---- Cisco 2621XM (IOS version ...