Finding accurate answers to your questions and issues is always gratifying, but what if these answers are shared globally across different languages? The Cisco Community team has been working on a proof of concept (PoC) to take Accepted Solutions in...
We currently have the following setup:2 - 2501 routers connected via a leased T1 line between our branch location and our main location.1 Cisco 1720 router at our branch location connected to our ISP.1 Cisco 1720 router at our main location connected...
This router runs IOS 11.1, see attempt to add route below - it just fails as if the command does not exist:Router>enPassword:Router#conf tEnter configuration commands, one per line. End with CNTL/Z.Router(config)#ip route 0.0.0.0 0.0.0.0 Serial0 ...
Sir I want to know about the ping response characters. How many are there and what do they show.
Hi,I am configuring a 1721 router for Internet access for a branch office with 30 employees. There will be a ASA5505 firewall behind the 1721. The ISP has provided 14 public Ethernet IP addresses. Is it more efficient to perform PAT or NAT? Is it ...
%ALIGN-3-TRACE: -Traceback= 402B4DA4 40ACAB98 40AC9238 401E9B44 401E9B30 00000000 00000000 00000000Can someone assist with this?
Hi,I am setting up a new network. Is NAT configured on the perimeter router, or the ASA5505 firewall?Thanks.
I have an GRE/IPSEC VPN tunnel backing up a T1 link. Telco problem brought the T1 down. Tunnel works/passes data but Window's name resolution was only working from "some" servers and pcs on either side of the tunnel. First, I was under the impressi...
Hi,I am little confused between two commands..plz explain the usuage ..address-family mdt or address-family ipv multicastRgds,Gaurav
On a cisco 6509 sup720, that has peerroutes and transit routes, is their a way to limit a customer to only the peerroutes. I've seen issues with a customer still sending me traffic that's not destined for any network in his bgp peer routes that I sen...
I have an X.25 over ISDN configuration which running on a 1721 router. I can telnet from a host to port 1998/tcp (XOT) on the router. This configuration is to be migrated to an 876 router, but I am unable to connect to the XOT port with the same conf...
I am wanting to connect multiple internet connections (T3,Cable Modem,DSL) each direcly connected to the switch and do load balancing between them. Of course each interface on the switch will have IP blocks setup and I need to NAT them.Before I buy a...
i have an existing connection to a single ISP (ASA_1 -> 2811_1 -> ISP1).We are adding a second ISP (ISP2) for redundancy and load sharing between the two WAN links. We want to maintain conncetivity if one ISP link is down.On my side, I am adding a se...
router 2611 IOS is gone.I tried to copy the IOS through xmodem.the IOS size is around 12.5 MB.When it starts copying the IOS it says the time remaining is around 6 hrs..i tried it yesterday and when it was around 45% it stopped and restarted again..F...
I am trying to figure out what IOS is needed on my 2620 to be able to run the command "crypto key generate ...".Thank you
we have GRE tunnel between data center and remote site on AT & T link in which IP MTU 1476 is configured in tunnel interface at remote site while and no Ip tcp adjust-mss command. And on data center end tunnel is configured with Ip tcp adjust-mss 143...
