Routing

Im having problem establishing a remote isdn bri site to establish the call to HQ.I can see that when i do the " clear int bri 1/0" the layer 1 active and layer 2 mutiple frames established.however when i try to do a test call " isdn test int bri 1/0...

Hi All,It is PCI requirment to go for RA can anyone give me suggestion how to do RA for cisco devices and points i hv to cover in that...Thanks in advance

Error That I am getting:%CRYPTO-3-CONNID_ALLOC_FAIL: Crypto engine failed to allocate a connection ID for negotiation from XXX.XXX.XXX.XXXRouters being Used: 2 Cisco 871Software: 12.3(8)YI2 in one and Version 12.4(4)T7 in the otherGetting the messa...

Is the throttle value above acceptable? The complaint is lagging internet and our network monitor does show them peaking at times...Rtr has been up about 6 months... Last clearing of "show interface" counters never Input queue: 0/75/50/0 (size/max/...

I had to setup and router with both protocols, im receiving the provider with the lan interface in area 1. I want change the configuration on my router to continous using ospf and additionaly i want setup other protocol like eigrp for other new provi...

Can anyone tell me if I can setup a monitor session and have the source and destination ports on different blades on the same switch? The switch in question is a catalyst 4507. The documentation says it has be be on the same switch, but all the exa...

I have a Cisco 821 router with 1 WAn and four Switch ports. I want to terminate another WAN connection on to the same route what steps should i take

We have t3 from verizon and t1 from xo.T3 is primary conn. T3 was down by few hours, and then back up, suppose all trffice will go through t3, but somehow it still go t1. does anyone have any idea?

I would like to configure a 1720 12.1(27b) with failover between two WIC's. I've been searching for a document that might describe some scenarios but I haven't found any. Please point me in the right direction. Thanks

Hi, thanks for stopping by.I'm having some difficulty load balancing two point to point T1's. This is a pretty basic transparent bridge as far as I understand it. I've followed the instructions in example 9 under doc id: 10676 to no avail. The mom...

Does anyone have the UNITY Architecture Overview of the new UNITY 5.0. I have the document that describes all of the components of 4.x but want something describing the 5.0 architecture.

HelloCould you say me if I can manage the wan network with Campus Manager ?(the wan network: area ospf sites connected each other with BGP. The ipsec tunnel exits between border BGP peers)Cdp is not enabled on the Cisco routers for the security reaso...

I found this configuration on on customer:!interface GigabitEthernet1 ip address 192.168.1.254 255.255.255.0!interface GigabitEthernet2 ip address 192.168.2.254 255.255.255.0!interface GigabitEthernet7 ip address 10.40.61.1 255.255.255.0!interface Gi...

Please send me the url to upload a newer version of IOS and remove the old one.