Routing

Hi all,Please take a look at the Figure 9. GLBP Deployment, Small Remote Site.http://www.cisco.com/en/US/partner/products/ps6550/prod_presentation0900aecd801790a3.htmlAssuming that the server is located behind the 10.44.11.0/30 and 10.44.12.0/30. The...

m getting thousands of hits on IDS with ospf packey length mismatch between two cisco routers..please let me know how to stop this...thanks in advanceregards..manik...

Is there anyway to verify the download and uprate speed on a IPSEC tunneel have going from our branch to our data center?We are utilizing cable internet service.Also...what would be the most efective way to test the pipe with load?

i have a 2811 router with a bvi interface with bridge-group f0/0 and vlan1 which vlan1 has clients connection to the network. Is it possible to have all the client(fa1/1, fa1/2,etc..)traffic pass through fa1/7???

Hello Guys, I am attempting configure Frame Relay on my 2 router. I have 2 serial cards only. Evidently I am not doing something right. I need to know if anyone has any documentation on how to configure a point to point using Frame Relay be...

Hi,I'm a little confuse and I don't know how it can be possible to do something with 2 distant sites linked with one NIC at each side.My first react was that I need to have 2 Nic and for best availability 2 link but my client have only one.So at each...

I need a clarification on the following:- We have about 25 sites that are linked to a core router. The 25 sites have different types of WAN links, some are on Frame Relay, P-To-P, or ATM. After reveiwing the network diagram,I inherited from a former ...

I have installed cisco vpn client on windows 2000 450MHz Intel Pentium III 384MB RAM with SMC1211TX Series NDIS 5.0 driver. On reboot, system crashes. I have to manually remove the cisco vpn client. Thne pc runs. Anyone know of incompatibility with t...

I have a client that purchased a 1920 cisco router. They have an nt1 coming into their remote office. Is it possible to interface the NT1 with the 1920 router? I know the 1700 series will work but it would be easier to use the 1920.Thanks,Alex

I have two routers at a central location. One is handling data communications and the other is handling voice communications. Data router died recently with a power supply issue. Power supply replaced, communications is back up. Now having other ...

I have two bgp neighbors, however one is in an ACTIVE state.This is a known issue, but my question is regarding the show tcp brief all commandboth bgp neigbors show LISTENshouldnt the one that is "working"be in an ESTABLISHED state?

I am hoping that someone could help me out with a rather simple QoS config for a Cisco 3845 with a single T1/CSU card in it.I have no VoIP running through this interface. I was hoping to put some limits on how much web and other traffic is used on t...

Hi,I have got a Cisco 1751 router with a WIC1T card for serial interface.On the Serial interface, i have my leased line internet modem connected through v.35 cable and configured static WAN IP given by ISPI take internet on FastEthernet interface wit...

What is a port channel on a switch? Can anyone explain?

Is there a cisco 800 Series Router that supports DSL/cable connectivity and QOS? I tried searching using the cisco IOS utility but I coudln't find what I was looking for.If not 800 what type of router would I need?ThanksRobert