Routing

how to know the exact memory installed in my router say 7206vxr. flash, dram, nvram. are there any computation?thanks

Hi I noticed that some router models display the clockspeed detected when we use"sh controllerse serial" command.But not all routers display the clock speed detected. Any specific way to findout how much is the current clock speed on a serial port.Ap...

I am considering the Cisco 1800 series routers for my branch offices. Presently, there are Adtran Netvanta 3305 units in place. The primary reason for considering replacing them is the lack of traffic shaping features to rate limit non-critical tra...

Hi,I want to configure the following test scenario:The router remote1 (Cisco 2611) of a remote location is connected to a central router central1 (7206) via isdn ppp multilink connection.If central1 fails, remote1 should dial to central2 (a second 72...

I am using BGP4 on a private internet, I have to establish a 400 peers on a CISCO router (7k2 NPG1). I would like to know if that are afordable figures I just not?.

I'm having some trouble w/ a T1 line that I've been troubleshooting. The link is steady (doesn't lose connectivity), but as soon as we start to pass traffic through it the data rate drops exponentially. Its like we're on an old 56k line when transf...

Hi,Can anyone tell me what this error message indicate? **ERROR**: call_progress: DEV_CONNECTED VOICE ERROR: Bearer capability not available(0x3A): b channel 17 call id 0x274CI've counter a problem with my VOIP where users can't hear the voice clearl...

Below is the partial configuration.My Query is when 3/0/0 and 3/0/1 ports are busy with local calls (calls starting with non zero numbers), then the local calls should be established on 2/1/x which are configured for calls starting with '0'. This con...

One of the major problems that i face alomost every day , is the problems with the WAN links.My network is based on leased lines. When i face a problem with a link i try to correct the problem by watching the status of the serial links. Some of my ac...

hi all,can anyone tell me what is the meaning of this phrase:If a Frame Relay DLCI is already assigned to one subinterface, the AutoQoS ? VoIP feature cannot be configured from a different subinterface. RegardsSadam

I have a point to point line between our UK and US office. I am pretty sure the config on the US side is good, however, I am not sure about the UK side. I just realized that I may have the wrong card, as British Telecom's equipment is saying that t...

hi allI am attaching the diagram.i am using BGP and OSPF in my 7613 router.In ospf i am using default-information originate.So becasue of thsi i am getting a default route in my 6513 switch.So my all lan traffic is forwading to 6513 and it is sending...

What Cisco managed switch models in the 12-48 port range support port rate settings down to 64kbps, and also in addition to this, what units support intelligent traffic shaping functions? Preferably a unit including some type of GUI would be useful ...

I am trying to discern what destination addresses are being hit via an access list: For example, I would like an access list created to see all hits going to 170.40.0.0.How do I go about creating this list without limiting traffic?access-list 90 ---...