Routing

Hi,If we are using the two routers are our regional offfice, i want to know that what is the reason of making tunnel between the two location(Router)and how i have to do tunnel between them (Configuration)And what are all the method of doing thatPlea...

HI.I have a 1600 router with two serials and one ethernet.and i have two incoming lines each of 128kbps that is to be connected to the serials, and the ethernet to my LAN.is there any way to balance between the two lines? and if i can what is the req...

Hello All,We have BGP & OSPF in our Network. Also we have implemented "Keepalive" command for the VPN Link.Since the VPN Link is for Backup Purpose but i see approxmiate usage of 50 kbps / 100 kbps of Link Usage on Continuous Basis.Is this Usage beca...

Hi : I am looking for configuration assistance with VRF and VLAN. running BGP routing protocol per VRFthank you

All, I want to do object tracking between two ISPs, one attached to my serial interface of my router and another that goes off to a broadband. I want the serial interface to have all traffic, unless it goes down completely, which the broadband will ...

hi all,this my first time here....hope you can help me.i have 2XT1,2811,WIC-1DSU-T1,WIC-1DSU-T1-V2.I am going to bundle them with MFR (hope that will work if not i will use MLPPP).My problem is that my 2811 doesn't recognize the WIC-1DSU-T1. when the...

All, I want to do object tracking between two ISPs, one attached to my serial interface of my router and another that goes off to a broadband. I want the serial interface to have all traffic, unless it goes down completely, which the broadband will ...

What I must make to synchronize NTP of a computer XP with a Router 2500. Annexed, commando that I execute from XP and error, "sh ver" of router, and configuration NTP in router ------------------------------------- C:\>net time \\192.168.50.1 System ...

We have a 1720 router with FW feature set. We currently have it inspecting traffic exiting INT S0.Now that we have a Pix behind this router we want to remove the inspection on this 1720 to free up CPU resources and hopefully improve the MLPPP problem...

i have question about the incoming traffic to my network from multiple link from same ISP and multiple link from different ISP.If i have two connection from same isp then i can use the MED for influancing the incoming traffic from the ISP to my netwo...

when do we have multiple labels or you can say label stack on Packet in MPLS networ?

Hi,I just purchase my first Cisco router 851 and trying to assign automatically the DNS server information my WAN interface received from my provider to a DHCP pool on the router.So far, I was only able to set manually the DNS info in the DHCP pool. ...

Hello Folks,Fairly simple question (not for me, however). We have a headend router connected via FR in a hub-n-spoke fashion. There are approx. 15 remote routers also connected into the FR net. The default routing protocol is RIP v1, although all ...

I config the qos as follwing:we would like24M for VoIP min34M for VoIP maxclass-map match-any AutoQoS-VoIP-RTP-Trustmatch ip dscp ef !Interactive Voiceclass-map match-any AutoQoS-VoIP-Control-Trustmatch ip dscp cs3 !Telephony Signalingmatch ip dscp a...