Routing

Hi All,I need some recommendation for command 'wrr-queue cos-map' for voice configuration.wrr-queue cos-map transmit_queue_# threshold_# cos1 [cos2 [cos3 [cos4 [cos5 [cos6 [cos7 [cos8]]]]]]]The cos value for VOICE bearer is: 5, VOICE signaling is: 3....

Hei,I have a Cisco 2611XM with RomMon 12.2(8r). Now I want to upgrade this router to 48MB Flash (32 MB Flash is still installed). I opened the case, but I see no further Flash-Slot to insert additional Flash. Who can help me ?SN: JHY0825K285Thanks in...

I have a lab setup and I am trying to configure advertise and non-exist maps.I have two routers "BGP" and "Edge" that are communicating via BGP. I am distributing the default route from the "BGP" router into the "Edge" router and that part is working...

I want to configure one of my switch interface as spam port.Can someone explain the whole process of spamming.

Dear All,Customer switch connect to ISP CE router. customer switch mark voice traffic as EF already, is it necessary to apply service-policy input command as ISP CE router? or just apply service-policy output command under the WAN link will do?Thank ...

I have two core swicthes connected to two diffrent routers .Both are router have seprate links to two diffrent destination.I have data and voice traffic i want to prefer one link for data and another link for voice traffic and i am using eigrp in my ...

Hi Folks,(diagram attached)I have a question regarding route maps + route re-distribution from ospf into BGP.Our network has 3 routers + currently runs ospf between them, we have upgraded our WAN links on router2 + router3-backup link to a new MPLS s...

Hello Experts!as a Security best practice do we need to Disable the Following on the Router:no ip source routeno ip bootp serverat the interface side:int x0/0no ip proxy arpno cdp enableI Do Appreciate ur valuable commentsALI

Hi guys, hope u r doing fine.I have a problem with private vlans.In a shared environment, I am supposed to host multiple webservers under a private vlan like PRIMARY VLAN 1 |_______________________| | || | || ...

I have MSFC card with 7 ports in 6506 switch. It is possible to connect 4507 switch so MSFC acts as a uplink. Kindly advice?

Hi everyone,I have given my router config below,My case is : as per ACL defined, I am able to communicate with the host/network, but my router is not able to communicate to another side client although the ACL allows the range of IP where router fall...

Hi Can anybody tell me , how i can configure per-packet& per-load load sharing using single OSPF with two differnt ISP . Please use Route-Map.Please give me some good document for understanding.-thanks

Dear Netpro,Wondering if anyone has installed the SIP-600 in a 7600 chassis (Cisco 7600 SIP 600 with 10-Port Gigabit Ethernet SPA). Is it able to be installed whilst the 7600 router is running (i.e. hotplug) or does the 7600 need to be shut down prio...