Routing

Folks, I do 'show ip int brief' on a remote Cat 3750 and I see the info pasted in the bottom of this message.My question is, is it a sure thing that the interfaces below are copper interfaces GigabitEthernet1/0/1, not fiber? Imagine I need to connect...

Hello,we have a problem with several Cisco 3825 and a VWIC-2MFT-E1DI module installed.When yoe connect 2 E1 links (channeled) on the interface there is an increasing number of CRC errors and also a loss of pings.After installing 2 moduls and putting...

Hello all,I have a Cisco 877W router that is connecting successfully to SBC DSL service. We can get out to the internet just fine, browse the web just fine (though I do have another question about DNS and what the clients "see" as their DNS server, ...

Hi,Does anybody know how to obtain serial number of 7200 router remotley.Regards,

I tried configuring an isdn wan connection recently and after inputting all the necessary data such as the isdn switch type, dialer list, the ip adds. of both bri0 interfaces and then manually mapping the ip adds to the corresponding telephone nos., ...

Hi, I have a router Cisco 871+ for Ethernet Access 1Mbps.However for the past few months, I have been encountering intermittent network disconnection at least twice a month. I have checked with my ISP - they have performed some circuit test on their ...

Greetings,I have an 1841 router eith a WIC-1B-U V2 card installed and not yet configued. The router also holds 2 WAN Ethernet connections through its FastEthernet ports Fa0/0 and Fa0/1.I need to know where to start to have the following configuration...

Hi All!I am not sure what the CF-Adapter-SP on the WS-SUP720-3B is and is it a bit of hardware connected to the SUP720 or is it part of software. Also, I had been told that the presence of the CF-Adapter-SR on the SUP depends on the spec of the SUP7...

Dearsir,one of customer is having 2821 router in head office and with 4 k.m range he was having branch office like that he was having 5 remote locations.in all locations hawas taking vpn lines to connect mpls network .now head office he was using 28...

Hello, Professionals I need to shape every ip address from /24 network to 10Mbit/s ingress speed. How to do this without write 253 ACL (one for every ip). I am sure there must be a more efficient way to do that... Please help me. Thanks , and have...

From this doc: http://www.cisco.com/en/US/products/hw/switches/ps700/products_tech_note09186a00801c8c4b.shtml#supported Burst?defines the maximum number of tokens that the bucket can hold at any one time. To sustain the specified traffic rate, burst ...